Page 1
2
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated dangerous voltage within the
products enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturers instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding- type plug. A polarized plug has two blades with one wider than
the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are provided
for your safety. If the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where
they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to
avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has
been dropped.
Do not expose this apparatus to drips or splashes.
<
Do not place any objects filled with liquids, such as vases, on the
<
apparatus.
Do not install this apparatus in a confined space such as a book
<
case or similar unit.
The apparatus draws nominal non-operating power from the
<
AC outlet with its POWER or STANDBY/ON switch not in the ON
position.
The apparatus should be located close enough to the AC outlet so
<
that you can easily grasp the power cord plug at any time.
The mains plug is used as the disconnect device, the disconnect
<
device shall remain readily operable.
If the product uses batteries (including a battery pack or installed
<
batteries), they should not be exposed to sunshine, fire or excessive
heat.
Caution should be taken when using earphones or headphones
<
with the product because excessive sound pressure (volume) from
earphones or headphones can cause hearing loss.
Page 2
3
WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
CAUTIONDO NOT REMOVE THE EXTERNAL CASES OR CABINETS TO EXPOSE
<
THE ELECTRONICS. NO USER SERVICEABLE PARTS ARE WITHIN.
IF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT,
<
CONTACT TEAC FOR A SERVICE REFERRAL. DO NOT USE THE
PRODUCT UNTIL IT HAS BEEN REPAIRED.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
<
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT
IN HAZARDOUS RADIATION EXPOSURE.
For U.S.A.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: Reorient or relocate the equipment and/or the receiving
<
antenna.
Increase the separation between the equipment and receiver.
<
Connect the equipment into an outlet on a circuit different
<
from that to which the receiver is connected.
Consult the dealer or an experienced radio/ T V technician for
<
help.
CAUTION
Changes or modifications to this equipments not expressly
approved by TEAC CORPORATION for compliance will void the
users warranty. This product has been designed and manufactured according to
FDA regulations title 21, CFR, chapter 1, subchapter J, based on the
Radiation Control for Health and Safety Act of 1968, and is classified
as class 1 laser product. There is not hazardous invisible laser
radiation during operation because invisible laser radiation emitted
inside of this product is completely confined in the protective
housings.
The label required in this regulation is shown
.
Optical pickup :
Ty p e : SF - D S1X D
Manufacturer: SANYO ELECTRIC CO., LTD.
Laser output: Less than 1.6 mW (Play) on the objective lens
Less than 47 mW (Record) on the objec tive lens
Less than 13 mW (Erase) on the objective lens
Wavelength: 785 nm
For U.S.A.
CLASS II apparatus with double insulation, and no protective
earth provided.