This is the 52 pages manual for Teac AI 501 DA Owners Manual. Read or download the pdf for free.
If you want to contribute, please mail your pdfs to info@audioservicemanuals.com.
Page: 1 / 52
Extracted text from Teac AI 501 DA Owners Manual (Ocr-read)
Page 1
2
IMPORTANT SAFETY PRECAUTIONS
CAUTION
oDO NOT REMOVE THE EX TERNAL CASES OR CABINETS TO
EXPOSE THE ELEC TRONICS. NO USER SERVICEABLE PARTS
ARE INSIDE.
oIF YOU ARE EXPERIENCING PROBLEMS WITH THIS PRODUCT,
CONTACT TEAC FOR A SERVICE REFERRAL. DO NOT USE THE
PRODUCT UNTIL IT HAS BEEN REPAIRED.
oUSE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF
PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY
RESULT IN HAZARDOUS RADIATION EXPOSURE.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
IN NORTH AMERICA USE ONLY ON 120 V SUPPLY.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated dangerous voltage within the
products enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
For Canada
Industry Canadas Compliance Statement:
This Class B digital apparatus complies with Canadian
ICES- 003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada .
For U.S. A.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
-
Reorient or relocate the equipment and/or the receiving
antenna.
-
Increase the separation bet ween the equipment and
receiver.
-
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/ T V technician
for help.
CAUTION
Changes or modifications to this equipment not expressly
approved by TEAC CORPORATION for compliance will void
the users warranty.
Microsoft, Windows XP, Windows Vista and Windows 7 are either registered trademarks or trademarks of Microsoft Corporation in the United
States and/ or other countries.
Apple, Macintosh and Mac OS are trademarks of Apple Inc., registered in the U.S. and other countries.
Other company names and product names in this document are the trademarks or registered trademarks of their respective owners.
Page 2
3
IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with
the manufacturer's instructions.
8) Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-
type plug. A polarized plug has two blades with one wider than
the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are provided
for your safety. If the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination
to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or
when unused for long periods of time.
14) Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has
been dropped.
oThe apparatus draws nominal non-operating power from the AC
outlet with its POWER or STANDBY/ON switch not in the ON position.
oThe mains plug is used as the disconnect device, the disconnect
device shall remain readily operable.
oCaution should be taken when using earphones or headphones
with the product because excessive sound pressure (volume) from
earphones or headphones can cause hearing loss.
oDo not expose this apparatus to drips or splashes.
oDo not place any objects filled with liquids, such as vases, on
the apparatus.
oDo not install this apparatus in a confined space such as a book
case or similar unit.
oThe apparatus should be located close enough to the AC outlet
so that you can easily reach the power cord plug at any time.
oIf the produc t uses bat teries (including a bat ter y pack or
installed batteries), they should not be exposed to sunshine, fire
or excessive heat.
oCAUTION for products that use replaceable lithium batteries: there
is danger of explosion if a batter y is replaced with an incorrect
type of battery. Replace only with the same or equivalent type.
Products with Class construction are equipped with a power sup -
ply cord that has a grounding plug. The cord of such a product
must be plugged into an AC outlet that has a protective ground -
ing connection.
CAUTION
WARNING
Q Precautions concerning batteries
Misuse of batteries could cause them to rupture or leak leading
to fire, injury or the staining of nearby things. Please read and
observe the following precautions carefully.
oBe sure to insert the batteries with correct positive ( +) and
negative ( _) orientations.
oUse batteries of the same type. Never use different types of bat -
teries together.
oIf the remote control is not used for a long time (more than a
month), remove the batteries to prevent them from leaking.
oIf the batteries leak, wipe away the leakage inside the battery
compartment and replace the batteries with new ones.
oDo not use batteries of types other than those specified. Do not
mix new batteries with old ones or use different types of batter -
ies together.
oDo not heat or disassemble batteries. Never throw batteries into
fire or water.
oDo not carry or store batteries with other metallic objects. The
batteries could short circuit, leak or explode.
oNever recharge a battery unless it is confirmed to be a recharge -
able type.
Nameplate
Front side
Page 46
47
4 Gire el mando INPUT SELECTOR para
seleccionar USB.
5 Comience la reproducción de un archivo
de música en el ordenador.
Suba al máximo el volumen del ordenador y utilice el
mando VOLUME de esta unidad para ajustar el nivel
de salida, ya que así obtendrá la mejor calidad de
sonido.
Baje al mínimo el volumen de esta unidad antes
de comenzar la reproducción y vaya subiendo el
volumen gradualmente.
oNo es posible controlar esta unidad desde el ordenador
ni controlar el ordenador desde esta unidad.
oNo lleve a cabo ninguna de las siguientes acciones
cuando se esté reproduciendo un archivo de audio
mediante la conexión USB. Si lo hace podría causar
anomalías de funcionamiento en el ordenador. Salga
del software de reproducción de música siempre
que vaya a llevar a cabo cualquiera de las siguientes
acciones:
- Desconectar el cable USB
- Apagar (OFF) esta unidad
- Cambiar la fuente de entrada de esta unidad
oSi conecta esta unidad con el ordenador o cambia su
entrada a USB después de haber iniciado el software de
reproducción de música, los archivos de audio podrían
no reproducirse correctamente. Si esto ocurre, reinicie
el sof tware de reproducción de música o reinicie el
ordenador.
ES