Sunfire tgr 401 230 owners manual

Page 1

User's Manual  1. Read Instructions . Keep these Instructions 3. Heed all Warnings. 4. Follow all Instructions 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not install near any heat sourc - es such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 8. Unplug this apparatus during light - ning storms or when unused for long periods of time. 9. Refer all servicing to qualified ser - vice personnel. Servicing is required when the apparatus has been dam - aged in any way, such as a power- supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 10. Ventilation - The apparatus should be situated so that its location or position does not interfere with its proper ventilation. For example, the apparatus should not be situated on a bed, sofa, rug, or similar surface that may block any ventilation openings; or placed in a built-in installation such as a bookcase, cabinet, or closed equip - ment rack that may impede the flow of air through ventilation openings. 11. Power Sources - The apparatus should be connected to a power sup - ply only of the type described in these operation instructions or as marked on the apparatus. 1. Power Cord Protection - Pow - er-supply cords should be routed so that they are not likely to be walked upon or pinched by items placed upon or against them, paying particular at - tention to cords at plugs, convenience receptacles, and the point where they exit the apparatus. 13. Non-use Periods -The power cord of the apparatus should be un - plugged from the outlet when unused for a long period of time. 14. Object and Liquid Entry - Care should be taken so that objects do not fall into and liquids are not spilled into the inside of the apparatus. 15. Servicing - The user should not attempt to service the apparatus beyond those means described in this operating manual. All other servicing should be referred to qualified service personnel. SAFETY Important Safety Instructions

Page 2

User's Manual 3 16. To prevent electric shock , do not use this polarized plug with an exten - sion cord, receptacle or other outlet unless the blades can be fully inserted to prevent blade exposure. Pour préevenir les chocs électriques ne pas utiliser cette fiche polariseé avec un prolongateur, un prise de courant ou une autre sortie de cou - rant, sauf si les lames peuvent être insérées à fond sans laisser aucune parIVe à découvert. 17. Grounding or Polarization - Precautions should be taken so that the grounding or polarization means of the Component is not defeated. This apparatus does not exceed the Class A/Class B (whichever is ap - plicable) limits for radio noise emissions from digital apparatus as set out in the radio interference regulations of the Ca - nadian Department of Communications. WARNING -“ TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRO- DUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUAU FOND. EXAMPLE OF ANTENNA GROUNDING ACCORDING TO NA TIONA L ELECTRICAL CODE INSTRUCTIONS CONT AINED IN AR TICLE 810-“RADIO AND TELEVISION EQUIPMENT GROUND CLAMP GROUNDINGCONDUCT ORS (NEC SECTION 810-21) ANTENNALEAD IN WIRE POWER SERVICE GROUNDINGELECTRODE SYSTEM(NEC ART 250, PART H) SERVICEENTRANCEEQUIPMENT GROUND CLAMPS GROUND CLAMPS ANTENNA DISCHARGE UNI T (NEC SECTION 810-20) NEC NATIONAL ELECTRICAL CODE. NOTE TO CATV INSTALLE R This reminder is to call the CATV system installer's attention to Articl\ e 820-40 of the NEC that provides guide-lines for proper grounding and in particular, specifies that the cable g\ round shall be connected to the groundingsystem of the building as close to the point of cable entry as practical\ . OUTSIDE ANTENNA GROUNDINGIf an outside antenna is connected to the receiver, be sure the antenna \ system is grounded so as to providesome protection against voltage surges and built-up static charges. Arti\ cle 810 of the National Electrical Code,ANSI/NFPA 70, provides information with regard to proper grounding of th\ e lead-in wire to an antenna-discharg e unit, connection to grounding electrodes, and requirements for the groun\ ding electrode. See Figure above. User's Manual User's Manual ATTENTION - Le présent appar - eil numérique n'émet pas de bruits radioélectriques dépassant las limites applicables aux appareils numériques de class A/de class B (selon le cas) prescrites dans le règlement sur le brouillage radioélectrique édicté par les ministere des communications du Canada. SAFETY