Sony rdr gx 300 owners manual

This is the 104 pages manual for sony rdr gx 300 owners manual.
Read or download the pdf for free. If you want to contribute, please mail your pdfs to info@audioservicemanuals.com.

Page: 1 / 104
left right
sony rdr gx 300 owners manual

Extracted text from sony rdr gx 300 owners manual (Ocr-read)


Page 2

WARNING

To prevent lire or shock hazard,
do not expose the unit to rain or
moisture.

To avoid electrical shock, do not
open the cabinet. Refer servicing
to qualitied personnel only.

The AC power cord must be
changed only at a qualified
service shop only.

CAUTION

The use of optical instrutnents with this
product will increase eye hazard, As
the laser beam used in this DVD
recorder is harmful to eyes, do not
attempt to disassemble the cabinet.
Refer servicing to qualified personnel
only.

This symbol is intended

to alert the user to the

presence of uninsulated

dangerous voltage"

within the product's
enclosure that may be of sufficient
magnitude to constitute a risk of
electric shock to persons.

This symbol is intended
to alert the user to the
presence of important
operating and
maintenance (servicing)
instmctions in the literature
accompanying the appliance.

CAUTIO N

TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG
TO WIDE SLOT, FULLY INSERT.

For customers in the U.s.A

Owner's Record

The model and serial numbers are located at
the rear of the unit.

Record the scrinl number in the space
provided below. Rctcr to them

whenever you call upon your Sony dealer
regarding this product.

Model No RDRVGXMKl

Sena] No.

CAUTION

You are cautioned that any change or
modifications not expressly approved
in this manual could void your
attthority to operate this equipment.

This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection agai st harmful interference
in a residential installation. This
equipment generates, uses. atid can
radiate radio frequency energy and, if
not installed aiid used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception. which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:

, Reorient or relocate the receiving
antenna.

, increase the separation between the
equipment and receiver.

7 Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.

7 Consult the dealer or an experienced
radio/TV technician for help.

VCR Plus+ aiid PlusCode are
registered trademarks of Genistar
Development Corporation. The VCR
Plus+ , stem is manufactured under
license frotn Gemstar Development
Corporation,

Precautions

This equipment has been tested and
found to comply with the limits set
out in the EMC Diicctivc using a
connection cable shorter than 3
meters.

0n safety

Should any solid object or liquid fall
into the cabinet, unplug the recorder
and have it checked by qualified
personnel befoic operating it any
further.

On power sources

. Thc recorder is not disconnected
from the AC power source as long
as it is connected to the wall outlet,
even if the recorder itself has been
turned off.

If you are not going to use the
recoidcr foi a long time, be sure to
disconnect the recorder from the
wall outlet. To disconnect the AC
power cord, grasp the plug itself;
nevcr pull the cord.

On placement

- Place the recorder in a location
with adequate ventilation to
prevent heat buildup in the
recoidcr.

Do not place the recorder on a soft
surface such as a rug that might
block the ventilation holes.

Do not place the recorder in a
confined space such as a bookshelf
or similar uitit.

Do not place the recorder in a
location near heat sources, or in a
place subject to direct sunlight.
ext. ive dust, or mechanical
shock.

Do not place the recorder in an
inclined position. It is designed to
be operated in a horizontal
position only.

chp the recorder and di. . away
from equipment with stiong
magnets, such as microwave
ovens, or large loudspeakers.

Do not place heavy objects on the
iccoidcr.

To picvcitt fire or shock hazaid, do
not place oblects filled with
liquids, such as vases, on the
apparatus.