Sony mds pc 1 owners manual

Page 2

(A!

To prevent fire or shock
hazard, do not expose the unit
to rain or moisture.

To avoid electrical shock, do
not open the cabinet. Refer
servicing to qualified
personnel only.

The laser component in this product
is capable of emitting radiation
ewecding the limit tor Class I.

CLASS 1 LASER PRODUCT
LUOKAN I LASEFILAITE

KLASS I LASERAPPARAT

This appliance is classified as a CLASS I
LASER product. The CLASS 1 LASER
PRODUCT MARKING is located on the
rear exterior.

The following caution label is located
inside of the unit.

cwnon mm: rim new mm- W my
mama; mwm am (noon; in u... .

A usvmc incestuous ma mm m7
wxsmnwme r. m u tin-um ml were:
mun-mm _ _ fl . 777

FURY my usinstmim m,
mmm oeormiv m sicnilmsvrnmssrwxa
memuucluicxr m smmi Ausssuen

IN NO EVENT SHALL SFLLER BE
LIABLE FOR ANY DIRECT,
INCIDENTAL OR
CONSEQUENTIAL DAMAGES OF
ANY NATURE, OR LOSSES 0R
l;X|l§N lib RESULTING FROM
ANY DEFECTIVE PRODUCT OR
THE USE OF ANY PRODUCT.

_
Precautions

0n safety

Should any solid obiect or liquid fall
into the cabinet, unplug the deck and
have it checked by qualified personnel
before operating it any further.

0n power sources

- Before operating the deck, check that
the operating voltage of the deck is
identical with your local power
supply. The operating voltage is
indicated on the nameplate at the rear
of the deck.

The unit is not disconnected from the

AC power source (mains) as long as it
is connected to the wall outlet, even if
the unit itself has been turned off.

- If you are not going to use the deck
for a long time, be sure to disconnect
the deck from the wall outlet. To
disconnect the AC power cord, grasp
the plug itself; never pull the cord.

' AC power cord must be changed only
at the qualified service shop.

0n placement

Do not install the appliance in a
confined space, such as a bookcase or
build-in cabinet because the mains
power switch (MAiN POWER) is
located on the rear exterior.

0n operation

If the deck is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may
condense on the lenses inside the deck
Should this occur, the deck may not
operate properly. In this case, remove
the MD and leave the deck turned on
for about an hour until the moisture
evaporates.

0n the MiniDisc cartridge

' Do not open the shutter to expose the
MD.

Do not place the cartridge where it
will he subtect to extremes of
sunlight, temperature, moisture in
dust.

On cleaning

Clean the cabinet, panel and controls
with a soft cloth slightly moistened with
a mild detergent solution. Do not use
any type of abrasive pad, scouring
powder or solvent such as alcohol or

hen/.inu.

If you have any questions or problems
concerning your deck, please consult
your nearest Sony dealer.

-
Welcome!

Thank you for purchasing the Sony
MiniDisc Deck. Before operating the
deck, please read this manual
thoroughly and retain it for future
reference.

-
About This Manual

This manual explains how to operate the
deck itself. For information about
operating the deck by personal computer,
refer to the operating instructions
supplied with the MD editor software.

Conventions

0 Controls in the instructions are those
on the deck; these may, however, be
substituted by controls on the remote
that are similarly named or, when
different, appear in the instructions
within brackets.

- The following icons are used in this
manual.

3 Indicates a procedure that
E requires use of the remote
-

*9 Indicates tips for making the

task easier and hints