Page 1
2
WARNING
To prevent fire or shock
hazard, do not expose the
unit to rain or moisture.
To avoid electrical shock, do
not open the cabinet. Refer
servicing to qualified
personnel only.
The mains lead must only be
changed at a qualified
service shop.
This appliance is classified as a
CLASS 1 LASER product. The
CLASS 1 LASER PRODUCT
MARKING is located on the
bottom exterior.
CAUTION
The use of optical instruments with
this product will increase eye
hazard. As the laser beam used in
this CD/DVD player is harmful to
eyes, do not attempt to disassemble
the cabinet.
Refer servicing to qualified
personnel only.
The following caution labels are
located on the laser protective
housing inside the enclosure
(except for Asian models).
Notice for customers in the
United Kingdom and
Republic of Ireland
A moulded plug complying with
BS1363 is fitted to this equipment
for your safety and convenience.
Should the fuse in the plug
supplied need to be replaced, a 5
AMP fuse approved by ASTA or
BSI to BS1362, (i.e., marked with
or mark) must be used.
If the plug supplied with this equipment has a detachable fuse
cover, be sure to attach the fuse
cover after you change the fuse.
Never use the plug without the fuse
cover. If you should lose the fuse
cover, please contact your nearest
Sony service station.
Precautions
Safety
- This unit operates on 220 -“ 240
V AC, 50/60 Hz. Check that the
units operating voltage is
identical with your local power
supply.
To prevent fire or shock hazard,
do not place objects filled with
liquids, such as vases, on the
apparatus.
Installing
Keep the player and discs away
from equipment with strong
magnets, such as microwave
ovens, or large loudspeakers.
Do not install the unit in an
inclined position. It is designed
to be operated in a horizontal or
vertical position only.
Do not place heavy objects on
the player.
The nameplate is located on the
bottom exterior.
Welcome!
Thank you for purchasing this
Sony CD/DVD Player. Before
operating this player, please read
this manual thoroughly and retain
it for future reference.
Page 2
3
Precautions
On safety
Caution -“ The use of optical instruments
with this product will increase eye hazard.
Should any solid object or liquid fall into
the cabinet, unplug the player and have it
checked by qualified personnel before
operating it any further.
On power sources
The player is not disconnected from the AC
power source (mains) as long as it is
connected to the wall outlet, even if the
player itself has been turned off.
If you are not going to use the player for a
long time, be sure to disconnect the player
from the wall outlet. To disconnect the AC
power cord (mains lead), grasp the plug
itself; never pull the cord.
On placement
Place the player in a location with adequate
ventilation to prevent heat build-up in the
player.
Do not place the player in a location near
heat sources, or in a place subject to direct
sunlight, excessive dust, or mechanical
shock.
Do not install the appliance in a confined
space, such as a bookcase or built-in
cabinet.
On operation
If the player is brought directly from a cold
to a warm location, or is placed in a very
damp room, moisture may condense on the
lenses inside the player. Should this occur,
the player may not operate properly. In this
case, remove the disc and leave the player
turned on for about half an hour until the
moisture evaporates.
Do not insert a disc with non-standard shape
(e.g., card, heart) into the player. The disc
may not be ejected and cause a malfunction.
When you move the player, take out any
discs. If you dont, the disc may be
damaged.
On adjusting volume
Do not turn up the volume while listening to
a section with very low level inputs or no
audio signals. If you do, the speakers may be
damaged when a peak level section is played.
On installing the player on the wall
If the player falls down, a serious injury or
damage may result. Observe the following
instructions to prevent the player from falling
down.
Install the player on a wall strong enough to
hold the player using two proper screws for
the wall material and strength.
Install the player on a vertical and flat wall
where reinforcement is applied. If you are
not sure about the wall strength or screws,
contact a screw shop or installer.
Install the player straight.
Do not install the player at high position.
Do not lean or hang on the player.
Do not load anything on the player.
Do not pull the connecting cords when the
player is on the wall.
Be careful not to trip on the connecting
cords.
When you operate the player, do not use
excessive force to operate the player, or
insert or remove the disc.
When cleaning, do not put hand on the
player or use excessive force.
