Page 2
3
CDX-M9900/M9905X
Notes on CD-Rs (recordable CDs)/CD-RWs (rewritable
CDs)
This unit can play the following discs:
Type of discs Label on the disc
Audio CD
MP3 files
-Some CD-Rs/CD-RWs (depending on the equipment used for
its recording or the condition of the disc) may not play on this
unit.
-You cannot play a CD-R/CD-RW that is not finalized-ˆ—
.
-You can play MP3 files recorded on CD-ROMs, CD-Rs, and
CD-RWs.
-A CD-R/CD-RW to which a session can be added can be played.
-ˆ—A process necessary for a recorded CD-R/CD-RW disc to be
played on the audio CD player.
EXTENSION CABLE AND SERVICE POSITION
When repairing or servicing this set, connect the jig (extension cable)
as shown below.
-Connect the MAIN board (CN401) and the SERVO board (CN2)
with the extension cable (Part No. J-2502-062-1).
NOTE FOR THE OPENING OF THE FRONT PANEL
In this set, the front panel is lowered to below the bottom face when
it is opened.
When servicing the set, place it on a stand having a height of about
2 cm.
FORCED FRONT PANEL OPEN/CLOSE
The front panel is forced to OPEN/CLOSE at the timing that the
power (ACC) is turned off.
If the Z button for the front panel is not effective, the following
method is used:
With the front panel open: The front panel is closed when ACC is
switched from ON to OFF edge.
With the front panel closed: The front panel is opened when ACC
is switched from ON to OFF edge.
NOTE FOR REPLACEMENT OF THE DIGITAL BOARD
When repairing, the complete DIGITAL board should be replaced
since any parts in the DIGITAL board cannot be repaired.
SERVO BOAR D CN2 MAIN BOARD
CN401
J-2502-076-1
stand
