Sony cdp c 615 service manual

Page 1

CDP-CBIES/ 0615

SERVICE MANUAL us Model

CDPCB7ES/CG 75

Canadian Model
AEP Model

E Model
Australian Model

GDP-06 15

Photo: CDP-CG7ES

Model Name Using Similar Mechanism GDP-0312M
CD Mechanism Type CDM16E2-SBDS
Optical Pick-Up Block Type BU-SBDS
SPECIFICATIONS
System Compact disc digital audio system DIGWAL OUT Wave length 550 nm
Laser Semiconductor laser (A=780 nm) (OPTICAL) OUDUI level -13 dBm
Emission duration: continuous (optical output
Laser output Max. 446 uW connector)
' This output is the value HEADPHONES Output level max 15 mW
measured at a distance of (stereo phone jack) Load impedance 32 ohms
about 200 mm lrom the
obiective lens sudace on the General
Optical Pick-up Block. Power requirements US and Canadian model:
Frequency response 2 Hz - 20 kHz (:05 dB) 129 VAC, 60 Hz
Signal to noise ratio More than 110 dB (ONES) Australian model:
More than 100 dB (Cat 5) AEPZAodl |AC. 50/60 Hz
Dynamic range More than 100 dB (CB7ES) 10 9:
More than 98 dB (c315) E Zc'folV-ZSO VAC, 50/60 HZ
Harmonic distortion Less than 0.0025% (1 kH2)(Ca7ES) 11:42 220-24ov 50/60 Hz
Less than 0.004% (1 kHz) (C815) Power consumption 13 w
Channel separation More than 105 dB (1 kHz) (CB7ES) i l
DImenSlOlIS Approx. 430x125><385 mm
More than 100 dB (1 kHz) (0815) (w/hld) (17X5X15l4 Inches)
Wow and flutter Below measurable limit not including projecting parts and
Outputs controls
We' ht A rox. 7 k 15 lbs 7 o . net Es
LINE OUT (FIXED) Output level 2 v (at 50 kiloohms) 9 Aggrox a k: :13 lbs 4 0:; net $215))
(phone jacks) Load impedance over 10 ' '
kiloonms
LINE OUT (VARIABLE) Output level max. 2 V .
(phono jacks) (at 50 kiloohms) - Continued °" next page '

Load impedance over 10

chPAci DISK PLAYER

Page 2

GDP-067ES/C615

Remote commander RM-De15

Remote control system Infrared control

Power requirements 3 V DC with two batteries size AA
(lEC esignation R6)

Supplied accessories
Connecting cord (1)

(2 phono plugs H 2 phone plugs)
Remote commander (1)

Size AA batteries (2)

Operating Manual (1)

Optional accessory
Audio Optical connecting cord FOG-15

Design and specifications subject to change without
notice.

te on the Transit Key

The transit key on the bottom exterior of the unit protects
the optical system against shock during transportation.
Before operating the CD player. be sure to remove the key
by following the instructions on the label. and store it in a
sate place.

When transporting the unit, replace the key in its original
hole and lock it in place

TABLE OF CONTENTS
Section @ Page Section M Page
1. GENERAL 6. EXPLODED VIEWS
1-]. Location of Controls ------------------------------------------------------ 5 6-]. Front Panel and Case Assemblies 23

2. DISASSEMBLY

2-1. Removal of Front Panel and Case Assemblies 7
2-2. Removal of Disc Tray Assembly ----------------------------------------- 7
2-3. Removal of Optical Pickvup Block Assembly -------------------------- 7
3. Ic101(CXA13720) PIN FUNCTION --------------------------- 8
4. ELECTRICAL BLOCK CHECKING 9
5. DIAGRAMS

5.1_ Circuit Boards Location 11
5.2, Semiconductor Lead Layouts ........................... ........

5-3l IC Block Diagrams-m-
5-4. Printed Wiring Boards -

5.5 Schematic Diagram

SA FETY-R ELATED COMPONENT WAR NING! I

COMPONENTS IDENTIFIED BY MARK A OR DOTTED
LINE WITH MARK A ON THE SCHEMATIC DIAGRAMS
AND IN THE PARTS LIST ARE CRITICAL TO SAFE
OPERATION. REPLACE THESE COMPONENTS WITH
SONY PARTS WHOSE PART NUMBERS APPEAR AS
SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB-
LISHED BY SONY.

6-2r Disc Tray Assembly - 24
6-3. ChassisAssembly" 25
6-4. Optical Pick-up Block Assembly (BU-SBD3) ------------------------- 26
7. ELECTRICAL PARTS LIST ............................... 27

For the European countries

CLASS I LASER PRODUCT
LUOKAN I LASERMITE

KMSS I USERAPPARAT

This Compact Disc player is
classified as a CLASS 1
LASER product.

The CLASS 1 LASER
PRODUCT label is located
on the rear exterior.

ATTENTION AU COMPQSANT AYANT RAPPORT
A LA SECURITE!

LES composmrs IDENTIFIES PAR UNE MARQUE A
sun LES DIAGRAMMES scHéMATioues ET LA LISTE
oEs PIECES SONT CRITIQUES POUR LA SECURITE
oe FONCTIONNEMENT. NE REMPLACER ces com
POSANTS oue PAR DES PIECES SONY DONT LES
NUMEnos som DONNES DANS cE MANUEL ou
DANS LES SUPPLEMENTS Puaués PAR soNV.