Sansui SLE DVD197 Owners Manual

Page 1

CAUTION: THIS DIGITAL VIDEO PLAYER EMPLOYS A LASER SYSTEM. TO ENSURE PROPER USE OF THIS PRODUCT, PLEASE READ THIS OWNER'S MANUAL CAREFULLY AND RETAIN FOR FUTURE REFERENCE. SHOULD THE UNIT REQUIRE MAINTENANCE, CONTACT AN AUTHORIZED SERVICE LOCATION-SEE SERVICE PROCEDURE. USE OF CONTROLS, ADJUSTMENTS OR THE PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. TO PREVENT DIRECT EXPOSURE TO THE LASER BEAM, DO NOT TRY TO OPEN THE ENCLOSURE. RADIATION MAY BE PRESENT WHEN THE ENCLOSURE IS OPENED. DO NOT STARE INTO THE BEAM. Location of the required marking The rating sheet and the safety caution are on the rear of the unit. CERTIFICATION: COMPLIES WITH FDA RADIATION PERFORMANCE STANDARDS, 21 CFR SUBCHAPTER J. Complies with FDA performance standards for laser products except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007. The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. TO PREVENT THE SPREAD OF FIRE, KEEP CANDLES OR OPEN FLAMES AWAY FROM THIS PRODUCT AT TIMES. CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS POLARIZED PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. CAUTION: Changes or modifications not expressly approved by the partly responsible for compliance with the FCC Rules could void the users authority to operate this equipment. Record the model number and serial number. Model number Serial number ENGLISH CLASS 1 LASER PRODUCT

Page 2

15) Apparatus should not be exposed to dripping or splashing, and objects filled with liquids, such as vases, should not be placed on the apparatus. 16) An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits, as contact with them might be fatal. 17) Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric shock. 18) Do not push objects through any openings in this unit, as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. Never spill or spray any type of liquid into the unit. 19) If an outside antenna or cable system is connected to the unit, be sure the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges, Section 810 of the National Electrical Code, ANSI/NFPA 70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. 20) When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. 21) Upon completion of any service or repairs to this unit, ask the service technician to perform safety checks to determine that the unit is in proper operating condition. 22) Keep your fingers clear of the disc slot as it is closing. It may cause injury. ANTENNA DISCHARGE UNIT (NEC SECTION 810-20) ANTENNA LEAD IN WIRE GROUNDING CONDUCTORS (NEC SECTION 810-21) GROUND CLAMPS POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250, PART H) GROUND CLAMP ELECTRIC SERVICE EQUIPMENT NEC NATIONAL ELECTRICAL CODE S2898A EXAMPLE OF ANTENNA GROUNDING AS PER THE NATIONAL ELECTRICAL CODE ENGLISH IMPORTANT SAFETY INSTRUCTIONS

Page 25

Using HOME MENU Playing a disc 1 Press SETUP during stop mode. HOME MENU will appear. 2 Press /// to select Disc Navigator, then press ENTER . Audio Settings Video Adjust Disc Navigator Play Mode Initial Settings HOME MENU DVD 3 Press / to select desired option, then press ENTER. Disc Navigator Title Chapter Some discs may not work Disc Navigator. Depending on a disc, you can select Title, Chapter, or both. - - 4 Press /// or Number Buttons (09) to select Title or Chapter, then press ENTER. Press SKIP ( ) or SKIP ( ) to move next/ previous page. Press RETURN to return to previous screen. - - Playing a file 1 Press SETUP during stop mode. HOME MENU will appear. 2 Press /// to select Disc Navigator, then press ENTER. 3 Press / to select folder, then press ENTER. Folder1 Folder2 Folder3 Folder4 00:00/ 00:00 0kbps 4 Press / to select file, then press ENTER. If you select JPEG file, unit shows the pictures one after another automatically. Press RETURN to go to previous step. NOTE: When music files and JPEG files are recorded in one disc, you can play simultaneously. Please select the music file then select the JPEG file. - - - Play mode AB repeat playback A-B repeat playback allows you to repeat selection between two selected points. 1 Press PLAY MODE during playback. Play Mode screen will appear. A(Start Point) B(End Point) Off A B Repeat Repeat Random Program Search Mode Play Mode 2 Press / to select A-B Repeat, then press  or ENTER. 3 Press / to select A(Start Point), then press ENTER. The start point is selected. 4 Press / to select B(End Point), then press ENTER. The end point is selected. Playback starts at the point that you selected. Playback stops at the end point and returns to Point A automatically, then starts again. To resume normal playback Select Off in step 3. NOTE: Some discs may not work Play Mode function. A-B Repeat playback does not work with MP3/WMA CD. - - Repeat playback 1 Press PLAY MODE during playback. Play Mode screen will appear. 2 Press / to select Repeat, then press  or ENTER . 3 Press / to select desired repeat option, then press ENTER. The unit automatically starts repeat playback after finishing the current title or chapter. To resume normal playback Select Repeat Off in step 3. Random playback 1 Press PLAY MODE during playback or stop mode.Play Mode screen will appear. 2 Press / to select Random, then press  or ENTER . 3 Press / to select desired random playback option, then press ENTER. The unit automatically starts random playback. To resume normal playback Select Random Off in step 3. NOTE: You cannot play Random for programmed contents (Random play is not permitted during Program playback). During Random playback, it may repeat the same title, chapter or track. Random playback does not work with MP3/WMA CD.- - -

Page 27

Video Adjust menu From the Video Adjust menu you can adjust various settings that affect how the picture is presented. 1 Press SETUP during stop mode. HOME MENU will appear. 2 Press /// to select Video Adjust, then press ENTER. Audio Settings Video Adjust Disc Navigator Play Mode Initial Settings HOME MENU DVD 3 Press /// to setting the option, then press ENTER. Sharpness Brightness Contrast Gamma Hue Chroma LevelFine Standard Soft Video Adjust 4 Press SETUP to save the setting. Sharpness Adjust sharpness of images. Brightness Adjust brightness of images. Contrast Adjust a ratio of brightness between the brightest part and the darkest part. Gamma Emphasize dark part of images. Hue Adjust a balance between green and red. Chroma Level Adjust color density. It is effective with animation or something with high color density. NOTE: It may not be very effective for some discs or files. - Quick guide for DVD menu operation You can change the default settings to customize performance to your preference. Setting procedure 1 Press SETUP in stop mode. HOME MENU will appear. 2 Press /// to select Initial Settings, then press ENTER. Audio Settings Video Adjust Disc Navigator Play Mode Initial Settings HOME MENU DVD 3 Press /// to select the desired option, then press ENTER. 4 Change the selection using /// or ENTER, by referring to the corresponding page 29. Repeat steps 3 and 4 to change other option. - 5 To clear HOME MENU screen, press SETUP.