Page 1
>Preface
ii
COPYRIGHT AND ACKNOWLEDGMENTS
Copyright © 2005 Primare Systems AB. All rights reserved.
Primare Systems AB
Renvägen 1
SE-352 45 Växjö
Sweden
The information in this guide is believed to be correct as of the date of
publication. However, our policy is one of continuous development and so the
information is subject to change without notice, and does not represent a
commitment on the part of Primare Systems AB.
Primare is a trademark of Primare Systems AB. All other product names are
trademarks or registered trademarks of their respective owners.
This guide was produced by Human-Computer Interface Ltd,
http://www.interface.co.uk
FCC Warning: This equipment generates and can radiate radio frequency
energy and if not installed and used correctly in accordance with our instructions
may cause interference to radio communications or radio and television
reception. It has been type-tested and complies with the limits set out in Subpart J,
Part 15 of FCC rules for a Class B computing device. These limits are intended to
provide reasonable protection against such interference in home installations.
EEC: This product has been designed and type-tested to comply with the limits
set out in IEC 60065 7.POWER CONNECTION
Warning: Before connecting power check that the required supply
voltage, indicated on the back panel, corresponds to your local AC
supply. If a different voltage is stated on the type plate do not connect the A32
Amplifier to the mains power, and seek advice from your dealer.
Safety instructions: To prevent fire or shock hazard, do not expose this
appliance to dripping or splashing. No objects filled with liquids, such as
vases, should be placed on the unit.
Do not place the unit near a heat source such as a radiator or fireplace.
If you want to build in the unit you need to be sure to allow space of at least
20cm behind, 10cm on both sides and 30cm above the top panel of the
unit. This is to prevent fire or damage caused by overheating. Also make sure
that the main switch is accessible.
Warning: Dangerous voltages inside. Do not open the cabinet. There are no
user serviceable parts inside. Repairs should be carried out by qualified
service personnel only.
Warning: In use the heatsinks will become too hot to touch (up to 70°C).
Replacing the fuses
Due to the large capacitance of the power supply smoothing capacitors, turn
off the mains power and wait at least 15 minutes before replacing a blown
fuse. Be sure to replace the fuse with one of the exactly same type and value.
§0 Preface.pm71/12/05, 10:56 am 2
Page 2
>
iii
Contents
Introduction WELCOME TO THE A32 AMPLIFIER................(1
USING THE A32 WITH OTHER PRIMARE
PRODUCTS................................................................(2
TECHNICAL SPECIFICATION.............................(2 Connecting the A32 Amplifier BACK PANEL CONNECTIONS...........................(3
POWER CONNECTION........................................(4
OUTPUTS...................................................................(4
INPUTS.......................................................................(4
STANDBY MODES...................................................(4
RS232 PORT............................................................(5 Index
§0 Preface.pm71/12/05, 10:56 am 3
