Page 1
2
WARNINGThis equipment is not waterproof . To prevent a fire or shock hazard, do not place any container filled with
liquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain or moisture. D3 4 2 1 3_A1_En
WARNINGTo prevent a fire hazard, do not place any naked flame
sources (such as a lighted candle) on the equipment.
D3 4 2 1 7a_A1_En
VENTILATION CAUTIONWhen installing this unit, make sure to leave space
around the unit for ventilation to improve heat radiation
(at least 20 cm at top, 10 cm at rear
, and 20 cm at each side).
CAUTION
The STANDBY/ON switch on this unit will not
completely shut off all power from the AC outlet.
Since the power cord serv es as the main disconnect
device for the unit, you will need to unplug it from the
AC outlet to shut down all power. Therefore, make
sure the unit has been installed so that the power
cord can be easily unplugged from the AC outlet in
case of an accident. To avoid fire hazard, the power
cord should also be unplugged from the AC outlet
when left unused for a long period of time (for
example, when on vacation).
D3 4 2 2 2a*_A1_En
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance. The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to
alert the user to the presence of uninsulated
dangerous voltage within the products
enclosure that may be of sufficient
magnitude to constitute a risk of electric
shock to persons. CAUTION:
TO PREVENT THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
CAUTION RISK OF ELECTRIC SHOCK
DO NOT OPEN
IMPORTANT
D3 4 2 1 1b_A1_En
Operating EnvironmentOperating environment temperature and humidit y:
+5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH
(cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in
locations exposed to high humidity or direct sunlight (or strong artificial light). D3 4 2 1 7c*_A2_En
WARNINGSlots and openings in the cabinet are provided for ventilation to ensure reliable operation of the product,
and to protect it from overheating. To prevent fire hazard, the openings should never be blocked or covered with items (such as newspapers, table cloths,
curtains) or by operating the equipment on thick carpet
or a bed.
D3 4 2 1 7b*_A1_En
Caution
To prevent fire hazard, the Class 2 Wiring Cable
should be used for connection with speake r, and
should be routed away from hazards to avoid damage
to the insulation of the cable.
D3 7 13 67*_A1_En
Re ad these instructions.
Keep these instructions.
Heed all warnings.
Fo llow all instructions.
Do not use this apparatus near water.
Clean only with dry cloth.
Do not block any ventilation openings. Install in
accordance with the manufacture rs
instructions.
Do not install near any heat sources such as
radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat.
Do not defeat the safety purpose of the polarized
or grounding type plug. A polarized plug has two
blades with one wider than the other. A
grounding type plug has two blades and a third
grounding prong. The wide blade or the third
prong are provided for your safety. If the provided
plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
Pr otect the power cord from being walked on or
pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
1)
2)
3)
4)
5)
6)
7)
8)
9)
10) Only use attachments/accessories specified by
the manufacturer.
Use only with the cart, stand, tripod, bracket, or
table specified by the manufacture
r, or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to
avoid inju ry from tip over.
Unplug this apparatus during lightning storms
or when unused for long periods of time.
Re fer all se rvicing to qualified serv ice personnel.
Serv icing is required when the apparatus has
been damaged in any way, such as power supply
cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
D3 7 13 69_En
11)
12)
13)
14)
NOTE:
This equipment has been tested and found to comply with the limits for a\
Class B digital device, pursuant to Part 15
of the FCC Ru les. These limits are designed to provide reasonable protection against \
harmful inte rference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy\
and, if not installed
and used in accordance with the instructions, may cause harmful inte rference to radio communications. However,
there is no guarantee that interf erence will not occur in a particular installation. If this equipment does cause
harmful interf erence to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interf erence by one or more of the following measures:
Re orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to\
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
D8 10 1 2_A1_En
Information to User
Alterations or modifications carried out without
appropriate authorization may invalidate the user s
right to operate the equipment.
D8 10 2_A1_En
WARNING: This product contains chemicals known
to the State of California and other governmental
entities to cause cancer and birth defects or other
reproductive harm.
D36 P5_C1_En
Page 2
3
IMPORTANT NOTICE
THE MODEL NUMBER AND SERIAL NUMBER OF
THIS EQUIPMENT ARE ON THE REAR OR BOT TOM.
RECORD THESE NUMBERS ON YOUR ENCLO SED
WA RRANTY CARD AND KEEP IN A SAFE PLACE
FOR FUTURE REFERENCE.
D36 AP9 1_A1_En
CAUTION
This product satisfies FCC regulations when shielded
cables and connectors are used to connect the unit
to other equipment. To prevent electromagnetic
interference with electric appliances such as radios
and televisions, use shielded cables and connectors
for connections.
D8 10 3a_A1_En
This product is for general household purposes. Any
failure due to use for other than household purposes
(such as long term use for business purposes in a
restaurant or use in a car or ship) and which requires
repair will be charged for even during the warranty
period.
K041_A1_En
The Safety of Your Ears is in Your HandsGet the most out of your equipment by playing it at a
safe level a level that lets the sound come through
clearly without annoying blaring or distortion and, most
importantly, without affecting your sensitive hearing. Sound can be deceiving. Over time, your hearing
comfort level adapts to higher volumes of sound, so
what sounds normal can actually be loud and
harmful to your hearing. Guard against this by setting
your equipment at a safe level BEFORE your hearing
adapts.
ESTABLISH A SAFE LEVEL: Set your volume control at a low setting.
Slowly increase the sound until you can hear it comfortably and clearly, without distortion.
Once you have established a comfortable sound level, set the dial and leave it there.
BE SURE TO OBSERVE THE FOLLOWING
GUIDELINES:
Do not turn up the volume so high that you ca nt
hear whats around you.
Use caution or temporarily discontinue use in potentially hazardous situations.
Do not use headphones while operating a motorized vehicle; the use of headphones may create a traffic
hazard and is illegal in many areas.
S001a_A1_E n WARNINGStore small parts out of the reach of children and
infants. If accidentally swallowed, contact a doctor
immediately
. D41 6 4_A1_En
FEDERAL COMMUNICATIONS COMMISSION DECLARATION OF CONFORMITY
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful inte rference, and (2) this device must accept any interf erence received, including
inte rference that may cause undesired operation.
Product Name: AV Re ceiver
Model Number: SC 99
Re sponsible Party Name: PIONEER ELECTRONICS (USA) INC.
SERVICE SUPPORT DIVISION
Address: 1925 E. DOMINGUEZ ST. LONG BEACH, CA 90810 1003, U.S.A.
Phone: 1 800 421 1404
URL: http://www.pioneerelectronics.com
D8 10 4*_C1_En
SC 99 only
This transmitter must not be co located or operated
in conjunction with any other antenna or transmitter.
D8 9 2 5_A1_En
5.15 5.25 GHz band is restricted to indoor operations
only.
D8 9 2 6_A1_En
This device complies with Indust ry Canada
licence exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may
not cause interf erence, and (2) this device must
accept any interf erence, including interf erence that
may cause undesired operation of the device.
D8 9 10 1_A1_En
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency (RF)
Exposure Guidelines. This equipment should be
installed and operated keeping the radiator at least
20 cm or more away from person s body (excluding
extremities: hands, wrists, feet and ankles).
D8 9 2 7 2_A2_En
This equipment complies with IC radiation exposure
limits set forth for an uncontrolled environment and
meets RSS 102 of the IC radio frequency (RF)
Exposure rules. This equipment should be installed
and operated keeping the radiator at least 20 cm or
more away from persons body (excluding
extremities: hands, wrists, feet and ankles).
D8 9 2 7 4_A1_En
