Pioneer ctm 5 r owners manual

Page 1

Operating
Instructions

MULTI-CASSETTE CHANGER

This manual is applicable for both CT-MSR and CT-M5R. For convenience, the illustrations employed in the explanations are of CT»M6R.

Thank you for buying this Pioneer product.

Please read through these operating instructions so you will
know how to operate your unit properly. After you have finished
reading these instructions, keep the manual in a safe place for
future reference.

In some countries or regions, the shape of the power plug and
power outlet may sometimes differ from that shown in the draw-
ings. However, the method of connecting and operating the unit
is the same.

WARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS APPLI-
ANCE TO RAIN OR MOISTURE.

IMPORTANT NOTICE

[For us. and Canadian models]

The serial number for this equipment is located on the rear panel.
Please write your serial number on your enclosed warranty card
and keep it in a secure area. This is for your security.

[For Canadian model]

This digital apparatus does not exceed the Class B limits for radio
noise emissions from digital apparatus set out in the Radio Inter-
ference Regulations of the Canadian Department of Communica-
tions.

[Pour le modeleCanadien]

L'interlérencesradioélectrique génerée par cet appareil numérique
de type B ne depasse pas les limites énoncees dans le Reglement
sur les perturbations radioélectriques, section appareil numérique,
du Ministere des Communications.

[For Canadian model]!

CAUTION: To PREVENT ELECTRIC SHOCK Do NOT
USE THIs (POLARIZED) PLUG WITH AN EXTENSION
CORD. RECEPTACLE OR OTHER OUTLET UNLEss THE
BLADES CAN BE FULLY INSERTED TO PREVENT BLADE
EXPOSURE.

ATTENTION: POUR PREVENIR LES CHOCS ELEC-
TRIOUES NE PAS UTILISER CETTE FICHE POLARISEE
AVEC UN PROLONGATEUR, UNE PRISE DE COURANT 0U
UNE AUTRE SORTIE DE COURANT. SAUF SI LES LAMES
PEUVENT ETRE INSEREES A FOND SANS EN LAISSER
AUCUNE PARTIE A DECOUVERT.

LINE VOLTAGE SELECTOR SWITCH

Only multi-voltage models are provided with this

switch.

u.s., Canadian, European, U.K., and Australian

models are not provided with this switch.

Mains voltages in Saudi Arabia are 127V and

220V only. Never use this model with 110V set-

ting in Saudi Arabia.

The line voltage selector switch is on the rear panel. Before your

model is shipped from the factory, this switch is set to the power

requirements of the destination. Check that it is set properly

before plugging the power cord into the AC wall socket. If the

voltage is not properly set or if you move to an area where the

voltage requirements differ, adjust the selector switch as follows.

1 . Disconnect the power cord.

2. Use a medium

3. Insert the screwdriver into the groove on the voltage selector,
and adjust so that the tip of the arrow points to the voltage
value of your area.

Set the voltage selector
for the voltage in your area.

Mediumsize screwdriver

This praduct complies with the Radio Interference require-
ments of the EC {European Community) Directive 87/308/EEC. "

g) PIONEER

The future d sound and vlslon.

Page 2

IMPORTANT 1

The lightning llash wrth arrowhead, wrtnrn an eoui.
lateral triangle, l5 intended to alert the user oi the
presence at uninsulated "dangemus voltage" WIlhln
the pioducls enclosure that may be ol sulllclent
magnitude to constitute a risk oi electric shock to
persons

CAUTION

RISK OF ELECTRIC SHOCK
DO NOT OPEN

CAUTION:

TO PREVENT THE RISK OF ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK). NO
USERSERVICEAELE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.

The exclamation point within an equilateral triangle is
rntended to alert the user oi the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance

IMPORTANT 2

If [he apparatus is filled wilhAC mains Dowel oul-
Iat(s). see REAR PANEL FACILITIES for convenient
connection 0' addmonal Hi-Fl compunenlfi). Make
8" connections In lhe AC outlel(s) and [he signal
terminals llrst Connect lhe plug to the wall socket
last, make sure that the power swttch is oii.

FOR USE IN THE UNITED
KINGDOM

The Wives In this mains lead ave coloured in accul-
dance with the following code:

Blue. Neutral

Brown lee

As the colours oi the wrres in the mains lead oi lhls
apparatus may not correspond With the coloured
marking identityino the terminals in your plug proceed
as lollows

The Wile which is coloured blue must be connetled m
the terminal which is marked wrth the letter N or
coloured black

The wire which rs coloured brown musl be connected
to the rermrnal which rs marked with the letter L or
coloured red.

Equipment sold in the wt. is not supplied with
a power plug.

READ INSTRUCTIONS 7 All the salety and operating
instructions should be lead befnle the appliance
is operated.

RETAIN INSTRUCTIONS - The operating instructions
should be retained (or lulure velslence.

MEED WARNING 7 All warnings on the appliance and
in me npelating instructions should be adhered to.

FOLLOW INSTRUCTIONS - All operating and use in-
slructions should be followed.

WATER AND MOISTURE - The appliance should not
be used near water 7 in! example, near a bathlub,
washbowl, kitchen sink, laundlv tub, in a we!
basement. or near a swimming pool. etc.

LOCATION 7 The appliance should be installed in a
stable location.

WALL on CEILING MOUNTING - The appliance
should not be mounted to a wall or ceiling.
VENTILATION - The appliance should be situated so
that its location or position does not inreriere with
its proper venlilatlon. For example, the appliance
should not be situated on a bed, solo, rug, or simi-
lar surlace that may block the ventilation npen~
ings: or. placed in a built-in installation, such as
a bookcase or cabinet that may impede the ilow

01 all thlough [he ventilaliun Onenlngs.

HEAT - The appliance should be situated away irom
heat sources such as radiators, hear registers,
stoves. 0v olhel appliances (including amplifiers)
that produce heat,

POWER SOURCES - The appliance should be can-
nected to a power supply only oi the type
described in the operating instructions or as
marked on the appliance.

POWERVCORD PROTECTION - Powerssupplv cords
should be routed so that lhey are not likely to be
walked on or pinched by items placed upon or
against them. paying particular attention to cords
al plugs, convenience leceplscles, and (he Doim
where they exil irom the appliance

POLARIZATION 7 ll vour purchased product is provldr
ed with a polallzed powel plug, please lead the lol-
lowrng instructions. This product is equipped with
a polarized alternating current line plug (a plug hav-
ing one blade wider than the otherl. This plug will
iii into the power outlet only one way. This is a
saietyieature. ll you are unable to insert the plug
tuiiy into the outlet. iry reversing the plug. lithe
plug should still iail to in, contact your electrician
m veplace you! obsolete cullel. Do not defeat the
salety purpose oi the polar-led plug

CLEANING - The appliance should be cleaned only
wilh a polishing cloth u! a soil dly clolh. Never
clean Wlh lurmture wax. benzme, insecticides or
other volatile liquids since they may corrode the
cabinet.

POWER LINES - An outdoor antenna should be
located away irom power lines.

NONUSE PERIODS - The power cord at the appliance
should be unplugged trorn the outlet when lelt
unused tor a long period of time.

OBJECT AND LIQUID ENTRV - Care should beraken
so that obiects do not tell and ' ' sare not spilled
into the enclosure through openings.

DAMAGE REQUIRING SERVICE 7 The appliance

should be serviced by a Pioneer authorized service

center or gualiiied service personnel when:

The powel-supplv cord or the plug has been

damaged; or

Objects have lallen. or liquid has been spilled into

the appllance, or

The appliance has been exposed to rain; or

The appliance does not appear to operate normally

or exhibits a marked change in periormance, or

The appliance has been dropped : or the enclosure

damaged.

SERVICING - The user should not attempt to service
the appliance beyond that described ln the oper
ating instructionshor ail other serv' g.contact
the nearest Pioneer authorized servrce center.

POWER thEs

SERVICE
ENTRANCE
CONDUCTORSv

SAFETY INSTRUCTIONS

OUTDOOR ANTENNA GROUNDING 7 If an outside

antenna is connected lo the antenna terminal, be
sure the antenna system is grounded so as to was
vlde some protection against voltage surges and
built up static charges.
In the u.s.A. section am at the National Elecrrre
cal Code, ANSI/NFPA No. 70-1934, provides
iniorrnaiion with respect to proper grounding oi
the mast and supporting structure, grounding ol
the lead-in wire to an antenna discharge unit. size
ct grounding conductors, location at antenna dis
charge unit. connection to grounding elecilodes.
and requirements tor the grounding electrode. See
Fig. A.

CART 7 An appliance and cart combination should be
moved wIlI'l care. cuick stops, excessive iorce,
and uneven suriaces may cause the appliance and
cart comoinalion to overturn.

r
al Use Not 0 AWG (5.3 mrnl cop»
per. No.8 AWG 15.4 mmll alumi»
num, No.17 AWG ll .0 rnrn-l
cappalrclad steel. blame wire, or
larger as ground wire.
bl Secure antenna lead- and
ground wires to house wtth stands
oli insulators spaced lrom'4 leer
ii 22 merersl to e reet (I .33
melelsl apart.
{9133A cl Mount antenna ischarge unit as
WIRE closely aspossihletowheieleadr
in enters house.
to EXTERNAL dl Use jumper wire not smaller than

A .
, ,ygmms 0F No.6AWG il:t.3rnrn~l copper, or

STAND OFF
iNleLATORs o

enouucr the equivalent. when a separate
cnounio antenna-grounding electrode is
a
WOUND WlRE an DgEiNANRAGE 5m >
SERVICE ENTRANCE CLAMPS unit a See NEC Section 810-21 lil.
EQUIPMENT GROUND
WIRE 3.!)

POWER SERVICE
GROUNDING ELECTRODE SYSTEM
leg rnterror rnetai water piper om
BONDING lu- Dnlv
JUMPER d 1. me

i
6.1! ii " RE

GROUND
CLAMPS

oNAL ANTENNA

GROUNDlNG ELECTRODE

EN 8 FEET l2.44 in)
THE EARTH
OUIRED Er

LOCAL CODES SEE

NEC sEchoN BIO 2i lll

2