This is the 5 pages manual for philips dvp 3252 service manual. Read or download the pdf for free.
If you want to contribute, please mail your pdfs to info@audioservicemanuals.com.
Page: 1 / 5
Extracted text from philips dvp 3252 service manual (Ocr-read)
Page 1
How to remove the CD manually from the tray
1. Please do as below instruction in case the tray can not be open:
I. Power off the DVD player.
II. Please gently push the guider and wait until the tray comes out (Figure1).
2-1
Figure 1
Page 2
Software upgrade
Preparation to upgrade software
1) Start the CD Burning software and create a new CD
project (Data Disc) with the following setting:
Label: DVPXXXX (No need the label name)
File Name: DVPXXXX_XX.BIN
Power on the set and open the tray, then press
<5><5>
to check the File Name.
Note: It is required capital letter for the File System
name
2) Burn the data onto a blank CDR
A. Procedure for software upgrade:
1) Power on the set and insert the prepared Upgrade
CDR.
2) The set will starts reading disc & response with the
following display TV screen:
Upgrade File DETECTED
Upgrade?
Press Play TO START.
3) Press button to confirm, then screen will
display :
Files coping-¦
UPGRADING-¦
4) The upgraded disc will automatically out when files
coping complete, then take out the disc.
5) About 1 minute later, the trace will automatically close
when upgrading complete.
B. Read out the software versions to
confirm upgrading
1) Power on the set and press
button on the remote control.
2) Press<1><3><7><9>button to check the
software information.
The software version and other information
are display on the TV screen as follows:
Version XX.XX.XX.XX (Main
version)
SUB-VER XX.XX.XX.XX (software
version of
application
software)
8032 XX.XX.XX.XX
Servo XX.XX.XX.XX (software
version of
Servo)
RISC XX.XX.XX.XX
DSP XX.XX.XX.XX
Region Code X
3-1
Caution: The set must not be power off during
upgrading, Otherwise the Main board will be
damaged entirely.