Page 2
Congratulations on your purchase and
welcome to Philips!
To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.
Supplied Accessories
-“ AC power cord
Top/front panels (See 1)
1 Source selector:CD/MP3 ,FM ,MW or
OFF
-“selects CD/MP3, FM or MW source of
sound
-“power off switch
2 2; -“star ts or pauses CD/MP3 playback
§ -ˆž
-“selects the next/previous track
-“ fast searches forwards/backwards
(press and hold the button)
PROG -“ programs tracks
9-“stops CD playback;
-“erases a CD program
3 Display -“shows the CD functions
4 MODE -“selects different play modes:
e.g. REPEAT or SHUFFLE (random
order)
5ALBUM +-“ For MP3-CD only: selects
albums
6OPEN-CLOSE-“ opens/ closes the CD
door
7TUNING -“ tunes to radio stations
8
VOLUME -“adjusts volume level
Back/bottom panels (See 1)
9Telescopic antenna-“ improves FM
reception
0Battery door -“ open to inser t 6 x 1.5V
R-14/ UM-2/ C-cells
!p-“ 3.5 mm stereo headphone socket
Helpful hints:The speakers will be muted
when headphones are connected to the set.
@AC MAINS~-“ inlet for power cord
CAUTION
Use of controls or adjustments or
performance of procedures other
than herein may result in unsafe
operation.
This set complies with the radio
interference requirements of the
European Union.
Power Supply
Whenever convenient, use the power supply
cord if you want to conser ve batter y life.
Make sure you remove the plug from the set
and wall outlet before inser ting batteries.
Batteries
1 Inser t 6batteries, type R-14, UM2or C-
cells(not included, preferably alkaline) with
the correct polarity.(See 1).
2 Replace the batter y door, making sure the bat-
teries are firmly and correctly in place. The set is
now ready to operate.
- Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to burst:
- Do not mix batter y types: e.g. alkaline with car-
bon zinc. Only use batteries of the same type
for the set.
English Controls/Power Supply Power Supply General Operation/Tuner
- When inserting new batteries, do not tr y to mix
old batteries with the new ones.
- Remove the batteries if the set is not to be used
for a long time.
Batteries contain chemical substances, so
they should be disposed of properly.
Using AC power
WARNING: Always check you have
completely switched off the set, before
you change or disconnect power supply.
1 Check if the power voltage,as shown on
the type plate located on the
bottom of the set,corresponds to your
local power supply. If it does not, consult your
dealer or ser vice center.
2 Connect the power cord to the
ACMAINS~ inlet and the wall socket. The
set is now connected and ready for use.
3 To switch the set off completely, withdraw the
power cord from the wall socket.
4Install the unit near the AC outlet and where
the AC power plug can be easily reached.
-Disconnect the power cord from the wall
socket to protect your set during heavy thun-
derstorms. Children could seriously injure
themselves as the free end of the cable may
still be live if only the connector is removed
from the MAINS socket at the back of the
unit.
The type plate is located on the
bottom of the set.
Helpful hints:
-“To avoid unnecessar y energy consumption,
always adjust the
Source selector toOFF after using the set.
Generaloperation
Switching on and off and selecting the
function
1 To select your sound source, adjust the
Source selectorto:CD/MP3,
FM ,
or MW .
2 To switch off the set, adjust the
Source selectorto
OFF position.
Adjusting volume
Adjust the sound with the VOLUMEcontrol.
Radio reception
1 Adjust the Source selectorto FM or MW to select your desired waveband.
2Tu r n TUNINGto tune to a station.
Helpful hints:
To improve radio reception
-For FM,extend, incline and turn the telescop-
ic antenna for best reception. Reduce its
length if the signal is too strong.
-For MW,the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.
AZ1133_CCR_Eng 1/15/08 10:01 Page 3
