Page 2
Getting started
RQT6977
3
(Inside of product)
THE FOLLOWING APPLIES ONLY IN THE U.S.A.
CAUTION!
THIS PRODUCT UTILIZES A LASER.
USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
DO NOT OPEN COVERS AND DO NOT REPAIR
YOURSELF. REFER SERVICING TO QUALIFIED
PERSONNEL.
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR PRODUCT DAMAGE, DO NOT
EXPOSE THIS APPARATUS TO RAIN,
MOISTURE, DRIPPING OR SPLASHING AND
THAT NO OBJECTS FILLED WITH LIQUIDS,
SUCH AS VASES, SHALL BE PLACED ON
THE APPARATUS.
CAUTION:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-‰ĄReorient or relocate the receiving antenna.
-‰ĄIncrease the separation between the equipment and receiver.
-‰ĄConnect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-‰ĄConsult the dealer or an experienced radio/TV technician for help.
Any unauthorized changes or modifications to this equipment would
void the users authority to operate this device.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
CAUTION LASER RADIATION WHEN OPEN.
DO NOT STARE INTO BEAM.
FDA 21 CFR / Class II
VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN.
AVOID EXPOSURE TO BEAM.
IEC60825-1 / Class 3b
SYNLIG OCH OSYNLIG LASERSTRĂ…LNING NĂ„R DENNA DEL Ă„R
Ă–PPNAD. BETRAKTA EJ STRĂ…LEN.
SYNLIG OG USYNLIG LASERSTRĂ…LING VED Ă…BNING.
UNDGÅ UDSÆTTELSE FOR STRÅLING.
SYNLIG OG USYNLIG LASERSTRĂ…LING NĂ…R DEKSEL Ă…PNES.
UNNGĂ… EKSPONERING FOR STRĂ…LEN.
AVATTAESSA OLET ALTTIINA NĂ„KYVĂ„Ă„ JA NĂ„KYMĂ„TĂ–N
LASERSĂ„TEILYLLE. Ă„LĂ„ KATSO SĂ„TEESEEN.
SICHTBARE UND UNSICHTBARE LASERSTRAHLUNG, WENN
ABDECKUNG GEĂ–FFNET. NICHT DEM STRAHL AUSSETZEN.
RAYONNEMENT LASER VISIBLE ET INVISIBLE EN CAS
DOUVERTURE. EXPOSITION DANGEREUSE AU FAISCEAU.
RQLXS0054
-“
-“
-“
-“
-“
-“
-“
-“
-“
-“
CAUTION
VARNING
ADVARSEL
ADVARSEL
VARO!
VORSICHT
ATTENTION
CAUTION:
TO PREVENT ELECTRIC SHOCK MATCH
WIDE BLADE OF PLUG TO WIDE SLOT,
FULLY INSERT.
Before moving the unit, ensure the disc trays are empty. Failure to do so will risk severely damaging the discs and the unit.
The lightning flash with arrowhead
symbol, within an equilateral triangle, is
intended to alert the user to the presence
of uninsulated dangerous voltage within
the products enclosure that may be of
sufficient magnitude to constitute a risk of
electric shock to persons.
CAUTION
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE SCREWS.
NO USER-SERVICEABLE PARTS
INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The exclamation point within an
equilateral triangle is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature accompanying
the appliance.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
