Page 1
2
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturers instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers)
that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug has
two blades and a third grounding prong. The wide blade
or the third prong are provided for your safety. If the
provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified
by the manufacturer, or sold with
the apparatus.
When a cart is used, use caution
when moving the cart/ apparatus
combination to avoid injury from
tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen
into the apparatus, the apparatus has been exposed to rain
or moisture, does not operate normally, or has been
dropped.
15. Damage Requiring Service Unplug the apparatus from the wall outlet and refer
servicing to qualified service personnel under the
following conditions:A. When the power-supply cord or plug is damaged, B. If liquid has been spilled, or objects have fallen into
the apparatus,
C. If the apparatus has been exposed to rain or water,
D. If the apparatus does not operate normally by following the operating instructions. Adjust only
those controls that are covered by the operating
instructions as an improper adjustment of other
controls may result in damage and will often require
extensive work by a qualified technician to restore
the apparatus to its normal operation,
E. If the apparatus has been dropped or damaged in any way, and
F. When the apparatus exhibits a distinct change in performance this indicates a need for service.
16. Object and Liquid Entry Never push objects of any kind into the apparatus through
openings as they may touch dangerous voltage points or
short-out parts that could result in a fire or electric shock.
The apparatus shall not be exposed to dripping or
splashing and no objects filled with liquids, such as vases
shall be placed on the apparatus.
Dont put candles or other burning objects on top of this
unit.
17. Batteries Always consider the environmental issues and follow
local regulations when disposing of batteries.
18. If you install the apparatus in a built-in installation, such
as a bookcase or rack, ensure that there is adequate
ventilation.
Leave 20 cm (8") of free space at the top and sides and 10
cm (4") at the rear. The rear edge of the shelf or board
above the apparatus shall be set 10 cm (4") away from the
rear panel or wall, creating a flue-like gap for warm air to
escape.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPARATUS TO
RAIN OR MOISTURE.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO
USER-SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated dangerous voltage within
the products enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to
persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
WARNINGRISK OF ELECTRIC SHOCK DO NOT OPEN RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
AVIS
PORTABLE CART WARNING
S3125A
Page 2
Precautions
3
1. Recording Copyright -Unless its for personal use
only, recording copyrighted material is illegal without the
permission of the copyright holder.
2.
AC Fuse -The AC fuse inside the unit is not
userserviceable. If you cannot turn on the unit, contact
your Onkyo dealer.
3.
Care -Occasionally you should dust the unit all over
with a soft cloth. For stubborn stains, use a soft cloth
dampened with a weak solution of mild detergent and
water. Dry the unit immediately afterwards with a clean
cloth. Dont use abrasive cloths, thinners, alcohol, or other
chemical solvents, because they may damage the finish or
remove the panel lettering.
4.
Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST
TIME, READ THE FOLL OWING SECTION
CAREFULLY.
AC outlet voltages vary from country to country. Make
sure that the voltage in your area meets the voltage
requirements printed on the units rear panel (e.g., AC 120
V, 60 Hz or AC 100-240 V, 50/60 Hz).
The power cord plug is used to disconnect this unit from
the AC power source. Make sure that the plug is readily
operable (easily accessible) at all times.
Pressing the [POWER] button to select OFF mode does
not fully shutdown the unit. If you do not intend to use the
unit for an extended period, remove the power cord from
the AC outlet.
5.
Preventing Hearing Loss
Caution
Excessive sound pressure from earphones and headphones
can cause hearing loss.
6.
Batteries and Heat Exposure
Warning
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat as sunshine, fire or the like.
7.
Never Touch this Unit with Wet Hands -Never
handle this unit or its power cord while your hands are wet
or damp. If water or any other liquid gets inside this unit,
have it checked by your Onkyo dealer.
8.
Handling Notes
- If you need to transport this unit, use the original packaging to pack it how it was when you originally
bought it.
- Do not leave rubber or plastic items on this unit for a long time, because they may leave marks on the
case.
- This units top and rear panels may get warm after prolonged use. This is normal.
- If you do not use this unit for a long time, it may not work properly the next time you turn it on, so be sure
to use it occasionally.
- When youve finished using this unit, remove all discs and turn off the power. 9.
Installing this Unit
- Install this unit in a
well-ventilated location.
- Ensure that theres adequate ventilation all around this unit, especially if its installed in an audio rack.
If the ventilation is inadequate, the unit may
overheat, leading to malfunction.
- Do not expose this unit to direct sunlight or heat sources, because its internal temperature may rise,
shortening the life of the optical pickup.
- Avoid damp and dusty places, and places subject to vibrations from loudspeakers. Never put the unit on
top of, or directly above a loudspeaker.
- Install this unit horizontally. Never use it on its side or on a sloping surface, because it may cause a
malfunction.
- If you install this unit near a TV, radio, or VCR, the picture and sound quality may be affected. If this
occurs, move this unit away from the TV, radio, or
VCR.
10.
Moisture Condensation
Moisture condensation may damage this unit.
Read the following carefully:
Moisture may condense on the lens of the optical pickup,
one of the most important parts inside this unit. - Moisture condensation can occur in the following situations:
- The unit is moved from a cold place to a warm place.
- A heater is turned on, or cold air from an air conditioner is hitting the unit.
- In the summer, when this unit is moved from an air conditioned room to a hot and humid place.
- The unit is used in a humid place.
- Do not use this unit when theres the possibility of moisture condensation occurring. Doing so may
damage your discs and certain parts inside this unit.
If condensation does occur, remove all discs and leave this unit turned on for two to three hours. By this time, the unit
will have warmed up and any condensation will have
evaporated.