Nakamichi NA 80 Owners Manual

Page 1

To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit. Cleaning the unit: Wipe off the dirt on the panel with a dry silicon or soft cloth. Failure to observe this precaution may result in damage to the monitor or unit. Cleaning the connector: Wipe off dirt on the connector of the unit and faceplate. Use a cotton swab or cloth. WARNING How to reset your unit Important to know... Maintenance Caution : Adjust the volume so that youcan hear sounds outside the car .Driving with the volume too high may cause an accident . Condensation: When the car is air-conditioned, moisture may collect on the laser lens. This may cause disc read errors. In this case, remove the disc and wait for the moisture to evaporate. The illustrations in this manual are examples used to explain more clearly how the controls are used. Therefore, what appears on the illustrations may differ from what appears on the actual equipment. If you experience problems during installation, consult your Nakamichi dealer. When you purchase external components, check with your Nakamichi dealer to make sure that they work with your model and in your area. Stop the car before operating the unit. Safety 3 Reset 2 To prevent deterioration, do not touch the terminals of the unit and faceplate with your fingers. 1 If this unit fails to operate properly, press the reset button. The unit return to factory setting when the reset button is pressed. 1 2 1 2 Do not expose the faceplate to direct sunlight, excessive heat, or humidity. Also avoid places with too much dust or the possibility of water splashing. What s in the box Main unit (with sleeve) Carrying case (for front panel) Disassembly tool (2pcs) Screw x 4pcs Front panel Remotecontrol User manual Trim plate ISO male connector 2 EN Check and identify the contents of your package: Keep the faceplate in its casing while detached. The faceplate is a precision piece of equipment and can be damaged by shocks or jolts. How to attach/detach the faceplate Preparation Attach Detach

Page 2

2 3 4 Control panelTrim plate mm1 8 2 53 mm 1 3 Trim plate Sleeve Control panel 1 2 1 Removing the unit Bend the appropriate tabs to hold the sleeve firmly in place. 2 Before attaching, make sure the direction of the escutcheon is correct. ( Wider hooks on the bottom side.) 1 Detach the control panel. 2 Engage the catch pin on the removal tools into the holes on both sides of the escutcheon, then pull it out. 3 Insert the disassembly tools deeply into the slots on each side, then follow the arrows instructions as shown on the right. Disassembly Sleeve Disassembly Trim plate Control panel 1 2 3 Installing the unit EN 3 ScrewDashboard Sleeve ( not included in this packing )