Page 1
M1 Turntable Instructions for Use Page 2of 8SAFETYINFORMATIONIssue 2: March 2004IMPORTANT! (U.K. only)
This unit is supplied in the U.K. with a mains lead fitted with a moulded 13 amp plug.
If, for any reason, you need to cut off this plug, please remove the fuse holder and dispose of
the plug safely, out of reach of children. It must not be plugged into a mains outlet.
The wires in the mains lead supplied with this appliance are coloured in accordance
with the following code:
Green and yellow..............Earth
Blue...............................Neutral
Brown................................Live
WARNING - This appliance must be earthedAs the colours of the wires of the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug
which is marked with the letter E or coloured green or green-and-yellow, or by the earth
The wire which is coloured brown must be connected to the terminal which is marked with the
letter L or coloured red.
The wire which is coloured blue must be connected to the terminal which is marked with the
letter N or coloured black.
If connecting to a BS1363 plug, a 13 amp fuse must be used.
WARNING:
Any modification to this product not expressly approved by Musical Fidelity who
is the party responsible for standards compliance could void the users authority to
operate this equipment.
Page 2
M1 Turntable Instructions for Use Page 3of 8GENERAL ADVICEIssue 2: March 2004INSTALLATION PRECAUTIONS and USER INFORMATIONYour new M1 turntable is designed and built to provide trouble-free performance, but as with
all electronic devices it is necessary to observe a few precautions:
Only connect the accessory power supply to a mains outlet having the same voltage as marked
on the rear label - the input voltage is not user-adjustable.
Always ensure that when disconnecting and reconnecting your audio equipment the mains
supply is switched off.
Position the mains lead and signal interconnects where they are not likely to be walked on or
trapped by items placed on them.
Do not use near water, or place water-filled containers for example drinks cans, on or near the
top surface. If water does spill inside, immediately pull out the mains plug from the wall
socket and inform your dealer, who should then check the unit before further use. Entry of
liquid into the turntable motor unit or power supply is dangerous, and may cause electric
shock or fire hazard.
Do not place either unit near heat sources such as radiators, direct sunlight or other equip-
ment. Although the mains power supply unit has been designed so that it may be left switched
on indefinitely, please note that it becomes slightly warm to the touch. This is normal, but the
power supply must be operated in a well ventilated area.
Do not remove covers or try to gain access to the inside. There are no internal user adjust-
ments. Refer all service work to an authorised Musical Fidelity agent.
NOTE: Unauthorised opening of the equipment will invalidate any warranty claims.
Dust regularly with a soft cloth or soft brush, but be careful when using cleaning or polishing
agents - they may harm the surface finish.
The electronics in modern hi-fi equipment is complex and may, therefore, be adversely affected
or damaged by lightning. For protection of your audio system during electrical storms, remove
the mains plugs and disconnect any aerial lead.
If after-sales service is required, to help your dealer identify the M1, please quote the serial
numberlocated on the rear panel of the power supply unit.
RADIO FREQUENCY INTERFERENCE (R.F.I)This product has been tested to ensure that its operation is not adversely affected by normal
background levels of R.F.I., and that it does not itself generate excessive amounts of interfer-
ence. However, if a problem persists, please contact your Musical Fidelity agent.
