Page 1
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturers instruc-
tions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other appa-
\b
\f
\f
9. Do not defeat the safety purpose of the polar- ized or grounding-type plug. A polarized plug
has two blades with one wider than the other. A
grounding type plug has two blades and a third
grounding prong. The wide blade or the third
prong are provided for your safety. If the pro-
\f
\f
\f
an electrician for replacement of the obsolete
outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from
the apparatus.
\f
\
the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or \f
or sold with the apparatus. When a
cart is used, use caution when mov-
ing the cart/apparatus combination
to avoid injury from tip-over. 13. Unplug this apparatus during lightning storms
or when unused for long periods of time.
! \f\f
"\f
- nel. Servicing is required when the apparatus
has been damaged in any way, such as pow-
er-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or
has been dropped.
15. Do not expose this apparatus to dripping or \f
# \f\f
$ \f "-
uids, such as vases, should not be placed on the
equipment.
Ne pas exposer cet appareil à des éclaboussures
ou gouttelettes dun liquide. Aucun objet rem-
plie de liquide comme par exemple un vase ne
doit être placé sur lappareil.
16. If this equipment is supplied with a power supply cord only, the mains plug of the power
supply cord shall remain readily operable. To
completely disconnect this apparatus from the
a.c. mains disconnect the plug from the a.c.
receptacle.
Si léquipement est uniquement alimenté par
%\f
\f
dalimentation doit demeurer aisément acces-
sible. Pour déconnecter complètement léqui-
pement du réseau dalimentation, déconnecter
\f
%\f
\f
murale.
17. If this equipment is supplied with AC /DC Adapter with separate power supply cord or the
AC/DC Adapter plugging directly into an a.c.
receptacle, they shall remain readily operable.
To completely disconnect this equipment from
the a.c. mains remove the AC /DC Adapter
mains power supply cord from the a.c. recep-
tacle or remove the AC /DC Adapter when it is
directly plugged into the a.c. receptacle.
Si léquipement est alimenté par un adaptateur
AC/DC munis dun cordon dalimentation ou
un adaptateur AC/DC qui est alimenté directe-
ment à la prise murale, ils doivent demeurer
aisément accessibles. Pour déconnecter com-
plètement léquipement du réseau dalimen-
tation, déconnecter ladaptateur AC/DC de la
prise murale ou déconnecter le cordon dali-
mentation de ladaptateur AC/DC de la prise
murale.
18. WARNING: Do not expose batteries or battery & '
the like.
AVERTISSEMENT: Les batteries ou bloc de
batteries ne doivent pas etre exposees a une
chaleur excessive telle que celle du soleil, feu
ou autre source de chaleur similaire.
19. CAUTION: danger of explosion if battery is in- correctly replaced. Replace only with the same
or equivalent type.
ATTENTION: danger dexplosion si la pile
nest pas remplacée correctement. Ne remplac-
er que par le même type ou un type équivalent.
20. Connect mains power supply cord only to a mains socket outlet with a protective earthing
connection.
21. Warning: The Ethernet connector of this equipment must not be directly connected to
a public network. Connection is to be made
only by way of a modem or router approved
for this purpose.
T \b
\f
\b
\b \b \b -
\f \b \b \b \b \f \b \b \f \f\b
\f \b
\b \b \b\f \f \b\b
\f \b \b \b \f\b\b\b \f \b \f \b
\f \f! " #\b \b
\b \b \b \f \b -
\b \b \b \f \b \b \f \b \b \b
\b $\f % \f\b\b \f \b \b\b -
\b !
ATTENTION:
RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
WARNING: TO REDUCE RISK OF
FIRE OR ELECTRICAL SHOCK, DO
NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
NO USER-SERVICEABLE PARTS INSIDE. RE-
FER SERVICING TO QUALIFIED PERSONNEL.
TO PREVENT THE RISK OF ELEC- TRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SER- VICEABLE PARTS INSIDE.
IMPORTANT SAFETYINSTRUCTIONS! PLEASE READ THEM BEFORE
OPERATING THIS EQUIPMENT.
a) User Information acc. to FCC15.21 as following:
Changes or modifications not expressly approved by
the party responsible for compliance could void the
users authority to operate the equipment.
b) Statement for Class B digital device acc. to FCC 15.105 as following:NOTE: This equipment has been tested and found to comply with the limits for a Class A/B
digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harm-
ful interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interfer-
ence to radio communications. However,
there is no guarantee that interference will
not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/ TV technician for help.
-This device complies with Industry Canada licence-exempt RSS stan-
dard(s). Operation is subject to the fol-
lowing two conditions: (1) this device
may not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.Le présent appareil est conforme aux
CNR dIndustrie Canada applicables
aux appareils radio exempts de licence.
Lexploitation est autorisée aux deux
conditions suivantes : (1) lappareil ne
doit pas produire de brouillage, et (2)
lutilisateur de lappareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
den compromettre le fonctionnement.
c) The device must be kept more than 20 cm from all persons. FCC INFORMATION
$' () * *\f\b\f
\b \b\f
\f\b
\b
contained in the Owners Manual supplied with this product
Outdoor Antenna Grounding
If an outside antenna or cable system is connected
to the product, be sure the antenna or cable system
is grounded so as to provide some protection against
voltage surges and built-up static charge. Article 810 of
the National Electrical Code, ANSI/NFPA 70, provides
information with reguards to proper grounding of the
mast and supporting structure, grounding of the lead-in
wire to an antenna discharge unit, and size of ground
conductors, location of antenna-discharge unit, con-
nection to ground electrodes and requirements for the
grounding electrode. +# \b \f ,\b +\b * ANSI/NFPA 70
2
Page 2
Disposal Instructions
Waste and Disposal Instructions3
It is advisable to remove the Lithium Battery from this
product and/or remote control when it is not used for an
extended period of time. This will help to extend battery
life and avoid possible damage to the product and/or
remote control.
BATTERY REMOVAL:
Perform the following steps to remove the battery from
the product and/or remote control: (
) (
- nect the AC Power Cord and/or AC/DC Adapter
from this product.
Note: Step 1 is not required when removing the Lithium
Battery from a remote control.
2. Press the tab and lift up on the Backup Battery Cov-
\f \f
!
and 2.
3. When removing the battery from a remote control proceed to step 4. To remove the battery from a
product proceed to step 5.
4. Refering to figure 3, press on the bottom edge of the battery to release the battery from the molded
battery socket. Then remove the battery from inside
of the Remote Control. Proceed to step 6.
* !
\f\f & + $
\b \f \f
\f\f
tip of the tool between the metal tab of the battery
socket and the left side of the battery. Then rotate the
tool to release the battery from the socket. Remove
the battery from inside of the product.
6. Reinstall the Battery Cover.
7. Store the battery in a cool dry place for future use or dispose of the battery in accordance with the local
regulations for lithium battery disposal. Batteries
should never be thrown away or incinerated.
BATTERY INSTALLATION:
Perform the following steps to install the battery into the
product and/or remote control: ; (
\f\f
) (
- nect the AC Power Cord and/or AC/DC Adapter
from this product.
Note: Step 8 is not required when installing the Lithium
Battery into a remote control.
CAUTION:
\b
\f
\f
\b
incorrectly installed. Only install one of
the approved Lithium Batteries listed
Long Life Lithium Coin Cell type battery is used in this
product and/or supplied remote control. This product
and/or supplied remote control may be supplied with a
battery depending on the country where this product
is purchased. When purchasing a battery for use in this
product and/or remote control, refer to the following list:This product and/or the remote control supplied with
this product may contain a coin/button cell battery.
If the coin/button cell battery is swallowed, it can
cause severe internal burns in just 2 hours and can
lead to death. Keep new and used batteries away from
children. If the battery compartment does not close
securely, stop using the product and/or remote control
and keep it away from children. If you think batteries
might have been swallowed or placed inside of the
body, seek immediate medical attention.
WARNING:
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD AVERTISSEMENT:
NE PAS INGÉRER LACCUMULATEUR,
!" " #$%!" &'(!"
[La telecommande fournie avec] Ce product con-
tient un accumulateur bouton. En cas d ingestion,
l accumulateur bouton, peut causer des brulures
internes severes en a peine 2 heures qui peuvent etre
mortelles. Conserver les accumulateurs neufs usages
hors de portee des enfants. Sile compartiment de l
accumulateur ne se ferme pas de maniere sure, ne
plus utiliser le produit et et le tenir hors de portee des
enfants. Encas de soupcon dingestion dun accumu-
later ou dintroduction dans une partie quelconque du
corps, demander immediatement un avis medical. Lithium Battery Type Battery Removal or Installation Lithium Battery
Fig u re 1 TA B
Fig u re 2 LIFT
UP Fig u re 8 Contact
Points
Fig u re 7 CR2032
3V
Battery Fig u re 3
Fig u re 4 CR2032 3V Fig u re 6 CR20323V
Tabs
Fig u re 5
Battery
Socket 9. Press the tab and lift up on the Backup Battery Cov-
\f \f
!
and 2.
10. When installing the battery into the remote control proceed to step 11. To install the battery into a
product proceed to step 12.
11. Orient the battery so the + symbol (engraved into
!
7. Then insert the battery into the socket. Make
sure the battery is touching both contact points and
is seated in the socket. Refer to figure 8.
12. Orient the battery so the + symbol (engraved into
! -
ures 5 and 6. Then insert the battery into the sock-
et. Make sure the battery is touching both contact
points and is seated in the socket.
13. Reinstall the Battery Cover.
. \f \b \b
\b \f
\b \f! 1\b\b\f \f \b
\b \b \f\f -
\b \b \b \f
\b\b \f\f! North American Waste of Electrical and Electronic
Equipment Directive
Lithium Battery, Types, Removal and Installation
Approved Lithium Batteries
Brand IEC No. ANSI/NEDA No.
Energizer CR2032 5004LC
1
Panasonic >!?@J?\bQX(
1
5004LC
1
1CR Lithium Coin Cells contain Perchlorate special handling may apply. For additional information go to https://www.dtsc.ca.gov/
hazardouswaste/perchlorate/
ATTENTION:
Danger dexplosion si la pile nset
pas remplacée correctement. Installer
uniquement lune des piles au lithium
approuvées énumérées ci dessous.