This is the 22 pages manual for McIntosh MC 2200 Service Manual.
Read or download the pdf for free.
If you want to contribute, please mail your pdfs to info@audioservicemanuals.com.
MC22°° PERFORMANCE LIMITS & RATINGS
r--PERFORMANCE------1 MONO: 0.1% maximum harmonic
distortion at any power lev-
Mclgtosh audfio :owerdratlings are in ac- e] From 250 mill iwatts to
cor ance wit t e Fe era Tra e Commis-
sion Regulation of November 4, 1974 con- I400 watts From 20 Hz to
cerning power output claims for ampii- 20,000 HZ
fiers used in home entertainment pro-
ducts.
INTERMODULATION DISTORTION
STEREO: O.l7 maximum if instantaneous
POWER OUTPUT peak power Sutput is #00 watts or less
per channel with both channels opera-
STEREO: 200 watts minimum ting For any combination of Frequen-
sine wave continuous aver- CWSZOHZt°Zm°m m
age DOWEF Output, per chan- MWE:0J%rmewmifgnuamamow
. - pea power output is 00 watts or less
I218] bOth ChannEIs oEeratIng for any combination of frequencies,
Into 1 ohm, 2 ohms, ohms, onzcozmow m
or 8 ohms load impedance,
Wh'Ch '5 FREQUENCY RESPONSE
14.] volts RMS across l ohm
20.0 volts RMS across 2 ohms t05Wt°w
28.3 volts RMS across 4 ohms 20HztoZOflOOHz,+0-OJSdB
40.0 volts RMS across 8 ohms 0HZt0l0W000HZ+°3fi
MONO: 400 watts minimum sine NOISE AND HUM
wave continuous average power
output into 0.5 ohm, l ohm, 9Sdeebw mtw wtwt
2 ohms, or 4 ohms load imped-
ance, which is:
l4.l volts RMS across 0.5 ohm
20.0 volts RMS across l ohm r-RATINGS-l
28.3 volts RMS across 2 ohms
40.0 volts RMS across 4 ohms
OUTPUT VOLTAGES
OquuT LOAD IMPEDANCE 25voHsfordBtHbmim Hnfi
STEREO: l ohm, 2 ohms, h ohms, DAMPING FACTOR
and 8 ohms; separate terminals
are provided for each output srmEo;IeacI OM1oMpuL SOatZ
ohms output, 30 at A ohms output,
l6 at 8 ohms output
MONO: 0.5 ohm, 1 ohm, 2 ohms,
and L} ohms; obtained by COI'l- MONO: 16 at 0.5 ohms, 50 at l ohm,
necting together the appro- 22$:f dms,am m h°hm
priate terminals of both chan-
"815 INPUT IMPEDANCE
l00,000 ohms
RATED POWER BAND
20 Hz to 20,000 Hz INPUT SENSITIVITY
Switchable: 0.75 volt or 2.5 volts-
Level control provided for higher
TOTAL HARMONIC DISTORTION iwutvohaws
STEREO: 0.l% maximum harmon- pOWER REQUIREMENTS
ic distortion at any power
level from 250 mi l l iwatts to IZO volts 50/60Hz, 70 to 550 watts.
200 watts per channel From
20 Hz to 20,000 Hz, both
channels operating