Page 1
The lightning flash with arrowhead symbol within an equilateral triangle is
intended to alert the user to the presence of uninsulated dangerous voltage
within the products enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user
to the presence of important operating and maintenance (servicing) instructions
in the literature accompanying the product.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. CAUTION:TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION:POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE
LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE
CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUAU FOND.
IMPORTANT SAFETY
INSTRUCTIONS
READ BEFORE OPERATING EQUIPMENT
This product was designed and manufactured to
meet strict quality and safety standards. There are,
however, some installation and operation precautions
which you should be particularly aware of. 1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install
in accordance with the manufacture's
instructions.
8. Do not install near any heat sources such as
radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce
heat.
9. Do not defeat the safety purpose of the
polarized or grounding-type plug. A polarized
plug has two blades with one wider than the
other. A grounding type plug has two blades
and a third grounding prong. The wide blade
or the third prong are provided for your
safety. If the provided plug does not fit into
your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit
from the apparatus.
11. Only use attachments/accessories specified
by the manufacturer.
12. Use only with the cart, stand, tripod, bracket,
or table specified by the manufacturer, or
sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
NOTE:This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures: - Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and receiver.- Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
NOTE:Changes or modifications not expressly approved
by the party responsible for compliance could void
the users authority to operate the equipment.
This Class B digital apparatus complies with
Canadian ICES-003.Cet appareil numérique de la Classe B est
conforme à la norme NMB-003 du Canada.13. Unplug this apparatus during lightning
storms or when unused for long periods of
time.
14. Refer all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way,
such as power-supply cord or plug is
damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does
not operate normally, or has been dropped.
Additional Safety Information!
- This product should not be placed in a
built-in installation such as a bookcase or
rack unless proper ventilation is provided
or the manufacturers instructions have
been adhered to.
- Apparatus shall not be exposed to
dripping or splashing and that no objects
filled as vases, shall be placed on the
apparatus.
- When the switch is in the OFF position,
the apparatus isnt completely switched-off
from the MAINS.
DECLARATION OF CONFORMITY U.S. Responsible Party: Marantz America, Inc.
100 Corporate Drive,
Mahwah, NJ, 07430, U.S.A.
TEL: 630-741-0300
Type of Product:
Model:DLP Projector
VP-15S1
This device complies with Part 15 of the FCC rules.
Operation is subject to the following conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
7 1 4 @ 6 @ D P W F S " .
Page 2
Lamp Handing Precautions
DANGER This SHP uses a high voltage glass mercury vapor
lamp. The lamp can break or fail to light if handled
wrongly during replacement or because of the
projectors surrounding temperature.
Lamp life also varies according to the lamp with
some even breaking or failing to light as soon as
they are used the first time. If the lamp breaks,
glass fragments may be scattered inside the lamp
unit and projector, and gas inside the lamp bulb
that contains mercury vapor may be emitted from
the projectors vent.
Before use, carefully read the projector user guide
and the lamp replacement instructions. Remember
to handle the lamp with care. In the event of
serious trouble, call for Marantz authorized dealer.
-Do not look directly into the lamp with bare
eyes while lit. The bright light can cause sore
eyes and impair vision.
-Do not directly expose skin to the light of the
lamp. Direct exposure can inflame the skin.
-Do not drop, impact, subject to excessive force
or otherwise damage the lamp.
-Replacing the lamp runs the risk of burns and
electric shock, therefore shut OFF power
supply, unplug the AC power cord from AC
power outlet and wait at least 60 minutes for
the lamp to cool down before attempting to
replace it.
-If the lamp breaks, unplug the AC power cord
from AC power outlet and call for Marantz
authorized dealer to replace it. Do not replace
the lamp yourself or clean up broken glass
inside the projector as this can result in cuts
and burns to you or damages inside the
projector.
-If the projector is hung from a ceiling or
installed in a high place, it is extremely
dangerous to replace the lamp. In this case, do
not replace or handle the damaged lamp
yourself.
CAUTION -The chance of the lamp breaking is high after
extended use. It is recommended to replace
the lamp when near the end of its designed
life. Do not use a lamp beyond the maximum
lighting time.
-Use only Marantz original lamp units. Check
the model code of the lamp unit matches that
in the user guide.
-Before replacing the lamp, read carefully
Lamp Unit Replacement in the user guide.
Replace the lamp as explained therein.
-Entrust disposal of a used lamp to a licensed
industrial waste handler or return it to the place
of purchase. Do not break the lamp or discard
with general waste.
-If the lamp breaks, leave the area immediately
and stay away for at least 30 minutes, and
ventilate the room so as not to inhale the
mercury vapor.
-If you inhale the mercury vapor, see a
physician immediately and follow his
instructions.
ENGLISH FOREWORDThis section must be read carefully before any
connection is made to the mains supply. WARRANTYFor warranty information, contact your local
Marantz distributor. RETAIN YOUR PURCHASE RECEIPTYour purchase receipt is your permanent record of
a valuable purchase. It should be kept in a safe
place to be referred to as necessary for insurance
purposes or when corresponding with Marantz. IMPORTANTWhen seeking warranty service, it is the
responsibility of the consumer to establish proof
and date of purchase. Your purchase receipt or
invoice is adequate for such proof. FOR U.K. ONLYThis undertaking is in addition to a consumers
statutory rights and does not affect those rights in
any way. EQUIPMENT MAINS WORKING SETTINGYour Marantz product has been prepared to
comply with the household power and safety
requirements that exist in your area. COPYRIGHTRecording and playback of some material may
require permission. For further information refer to
the following:
- Copyright Act 1956
- Dramatic and Musical Performers Act 1958
- Performers Protection Acts 1963 and 1972
- Any subsequent statutory enactments and
orders
WARNINGS-Do not expose the equipment to rain or
moisture.
-Do not remove the cover from the equipment.
-Do not insert anything into the equipment
through the ventilation holes.
-Do not handle the mains cord with wet
hands.
-Do not cover the ventilation with any items
such as tablecloths, newspapers, curtains,
etc.
-No naked flame sources, such as lighted
candles, should be placed on the equipment.
-When disposing of used batteries, please
comply with governmental regulations or
environmental public instructions rules that
apply in your country or area.
-Make a space of about 0.2 meter around the
unit.
-When the projector is mounted on the ceiling,
the Ceiling Mount Kit approved by MARANTZ
must be used for installation.
-Do not look into the lens when the projector
is turned on. It could damage your eyesight.
-Unplug the projector from the wall outlet if it
is not to be used for a few days.
-No objects filled with liquids, such as vases,
shall be placed on the equipment.
-When the switch is in the OFF position, the
equipment is not completely switched off
from MAINS.
-The equipment shall be installed near the
power supply so that the power supply is
easily accessible.
7 1 4 @ 6 @ D P W F S " .
