Kenwood TK 8180 Service Manual 2

Page 39

3 CONNECT THIRD PARTY OPTIONS

3.2 ANI Board

You can install the ANI board to the transceiver. This
section describes how to install the CIMARRON QE-2 to
the transceiver.

Refer to the following URL for the information about the
ANI board (OE-2).

http://www.cimtechcorp.com/qe1manual.pdf

Confirm that G, A. and P are soldered (bridged).

l Items Required to Install
- Transceiver 3. Configure each signal logic of optional board
. QE_2 according to following table.
Refer to 1.2 26- in Accesso Connector.
- Adhesive Tape supplied with the QE-2. ( p ry )
. Cushion Tape Table 3-2 Terminal Description
Land Name IIO Board Function REMARKS
OPT1 0 Channel Busy Busy H/ LOK L
CAUTION _
- OPTS l KEY Active L
YOU MUST TURN THE TRANSCEIVER OFF AND REMOVE opT4 0 pm Active L
THE POWER CABLE BEFORE CONNECTING THE OPTION _
INTO THE TRANSCEIVER. OPT5 0 Emergency Active L
OPT2 | Aux l/O Active L
GND 0 V , -
3.2.1 QE-2 Board 532 I v + 7.5V typ
. . . 83 8.0V typ
1. Unplug the QE-2 board from the connector If It Is _
attached. STON O Sidetone 1kHz 5Vpp
- - lNH . Active L
2. M f f h E-2 f ll .
0:: y and con Igure t e O board as o ows AUDIH I Aud Inhlb (Mic Mute)
- uck and remove the solderin on K.
9 DNA 0 Data Out 600mVpp
DTI STD

OPT6 O Man~Down Active L

TCNT Active H

TCTL ' mec (Tone Sound)

Note: The radio Zone configuration includes Trunking or
mixed Trunking and conventional mode, CH busy"
should be configured Transmit Mode as Trunking.
Otherwise, when the radio is used under
conventional mode only, CH busy should be
selected Conventional" for Transmit Mode.

_ Solder the position between G and A We have checked a radio working under following
' condition of QE-2.

Transmit Option;

- Conventional Only
Transmit Mode=Conventional
Attack Delay=325ms
check Busy when Hi

- Trunking and Mix with some
Transmit Mode=Trunking
Trunk Select Debounce Time=200ms
check Trunk Available when Low

PTT Option; check Key Follow PTT [TOT].

These setting depend of your system. Please make sure
each timing and configuration consisted your System.
35 Modification Information Version: 1.13 USA