Jvc DRM 10 SAG Service Manual

Page 2

1.

SPECIFICATION

ower requ nt - ~,
r consump ower on :
Power off: 17.6 W
emperature pera ng : ° to
Storage : -20°C to 60°C
ra on on
mm x mm X

. , cm:
or er.

ormat
ormat, ormat
mum rs .
(XP) : Approx. 1 hour, (SP) : Approx. 2 hours, (LP) : Approx. 4 hours, (EP) : Approx. 6 hours, (FR) : Approx.
1 hour - 8 hours

cm 2
cm 1
cm:

H C

uper eo
eo
ng system y
Linear (XP mode only)
n compr s m

eo nput : . - p-p, 9
c : 0.2 - 0.4 Vp-p, 75 9
output

: . p-p, £2
C : 0.3 Vp-p, 75 fl
nput . - . p-p, Q n
output . p-p, Q
nput , n rrespo to mono
ut

. n or nput
mponent output : . p-p, £2
PB/PR : 0.7 Vp-p, 75 o
Correspondi to protection
- m, nm
. p-p, ms to y
Bit stream
Selectable in digital audio output setting menu
na 3 m r n a rome
ca +
un s em reque 5 es tuner
anne coverage ow - -
UH 470 MHz - 870 M Ad ustable E28 - E60
p rox.

, ca e, nput e t- _ , ,nput I
EEOHUIPUI Cable Adapter, Infrared remote control unit, Cable Adapter, Infrared remote control unit, "R6" battery x
R6 battery X 2 2,Conversron

Specifications shown are for SP mode unless othenNise specified.

E.& O.E. Design and specifications subject to change without notice.

Manufactured under licence from Dolby Laboratories. Dolby" and double-D symbol are trademarks of Dolby Laboratories.

DTS and DTS Digital Out" are trademarks of Digital Theater Systems, Inc.

G-CODE is a trademark of Gemstar Development Corporation and is registered in the following countries: Australia, China, Hong Kong, Japan,
South Korea, New Zealand, and Taiwan. SHOWVIEW is a trademark of Gemstar Development Corporation and is registered in the following coun-
tries: Austria, Belgium, Czech Republic, Denmark, Finland, France, Germany, Greece, Hungary, Iceland, Italy, Luxembourg, Netherlands, NonNay,
Poland, Portugal, Russia, Slovakia, South Africa, Spain, Sweden and Switzerland.

The G-CODE/SHOWVIEW system is manufactured under license from Gemstar Development Corporation.

G-CODE and SHOWVIEW are different trademarks used to represent the same easy recording feature. However, for simplicity, only the term G-
CODE will be used in the instructions. If you use SHOWVIEW system, follow the same steps listed for the G-CODE system.

This product incorporates copyright protection technology that is protected by method claims of certain US. patents and other intellectual property
rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision
Corporation, and is intended for home and other limited viewing users only unless othenivise authorized by Macrovision Corporation. Reverse engi-
neering or disassembly is prohibited.

2 (No.YD025)