Digitech tec 4x owner manual

This is the 8 pages manual for digitech tec 4x owner manual.
Read or download the pdf for free. If you want to contribute, please mail your pdfs to info@audioservicemanuals.com.

Page: 1 / 8
left right
digitech tec 4x owner manual

Extracted text from digitech tec 4x owner manual (Ocr-read)


Page 1

2 U.K. MAINS PLUG WARNING A moulded mains plug that has been cut off from the cord is unsafe. Discard the mains plug at a suitable disposal facility. NEVER UNDER ANY CIRCUM- STANCES SHOULD YOU INSERT A DAMAGED OR CUT MAINS PLUG INTO A 13 AMP POWER SOCKET. Do not use the mains plug without the fuse cover in place. Replacement fuse covers can be obtained from your local retailer. Replacement fuses are 13 amps and MUST be ASTA approved to BS1362. These symbols are internationally accepted symbols that warn of potential haz- ards with electrical products. The lightning flash means that there are danger- ous voltages present within the unit. The exclamation point indicates that it is necessary for the user to refer to the owners manual. These symbols warn that there are no user serviceable parts inside the unit. Do not open the unit. Do not attempt to service the unit yourself. Refer all ser- vicing to qualified personnel. Opening the chassis for any reason will void the manufacturers warranty. Do not get the unit wet. If liquid is spilled on the unit, shut it off immediately and take it to a dealer for service. Disconnect the unit during storms to prevent damage. C A U T I O N A T T E N T I O N :R I S Q U E D E C H O C E L E C T R I Q U E - N E P A S O U V R I R W A R N I N G : T O R E D U C E T H E R I S K O F F I R E O R E L E C T R I C S H O C K D O N O T E X P O S E T H I S E Q U I P M E N T T O R A I N O R M O I S T U R E R I S K O F E L E C T R I C S H O C K D O N O T O P E N WARNINGFOR YOUR PROTECTION, PLEASE READ THE FOLLOWING: WATER AND MOISTURE: Appliance should not be used near water (e.g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc). Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. GROUNDING OR POLARIZA TION: Precautions should be taken so that the ground- ing or polarization means of an appliance is not defeated. POWER CORD PROTECTION: Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. SERVICING: To reduce the risk of fire or electric shock, the user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. FOR UNITS EQUIPPED WITH EXTERNALL Y ACCESSIBLE FUSE RECEPTACLE: Replace fuse with same type and rating only. ELECTROMAGNETIC COMP ATIBILITY Operation is subject to the following conditions:- this device may not cause harmful interference, and - this device must accept any interference received, including interferencethat may cause undesired operation. - use only shielded interconnecting cables. - operation of this unit within significant electromagnetic fields should be avoided. DECLARATION OF CONFORMITY Manufacturers Name: DOD Electronics Man ufacturers Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USA declares that the product: Product Name: Tec4X Product Options: All (requires a Class II power adapter that conforms to the requirements of EN 60065, EN 60742, or equivalent). conforms to the following product specifications: Safety: EN 60065 (1993) IEC 65 (1985) with Amendments 1,2,3 EMC: EN 55013: (1990) EN 55020: (1991) Supplementary Information: The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC as amended by directive 93/68/EEC. DOD Electronics President 8760 S. Sandy Parkway Sandy, Utah 84070, USA Effective: (4/13/98) European Contact: Your Local DOD Sales and Service Office or International Sales Office 3 Overlook Drive #4 Amherst, New Hampshire 03031, USA Tel: (603) 672-4244 Fax: (603) 672-4246