Page 2
3 Placing and connecting
Please switch off all your High-End units before continuing.
Place the Enhanced Power Supply EPS right beside or with a minimum
distance of 15 cm above your Audionet PRE 1, PRE 1 G2, PRE 1 G3,
PAM, CAT, MAP, MAP 1, VIP G2 or ART G2 (=mother unit). Connect
the EPS to the mother unit using the provided cable.
Make sure the voltage specifications printed on the rear of the EPS match
your actual power voltage.
Connecting PRE 1, PRE 1 G2, PAM or CAT:
Now remove the power cord from the mother unit and plug it into the
EPS instead. The system is now ready to use.
Note: Inserting a second power cord to the PRE 1, PRE 1 G2, PAM or
CAT is not necessary and can decrease sound quality. Use only one
power cord. Due to this there is no power cord provided with the EPS.
Connecting MAP, MAP 1, PRE 1 G3, VIP G2 or ART G2:
Note: In contrast to the other mother units, when connecting a MAP,
MAP 1, PRE 1 G3, VIP G2 or ART G2 to the EPS both units must have
inserted a power cord. For further details please refer to the users man-
ual of your MAP, MAP 1, PRE 1 G3, VIP G2 or ART G2.
