Page 1
22. AC LINE IN: Connect the power cord here,
making sure it is fully seated in the socket.
Plug the male end of the cord into a grounded AC outlet. DO NOT DEFEAT THE GROUND
PRONG OF THE AC PLUG!
23. FOOTSWITCH: Connect a two-button
footswitch here for control of muting and chan -
nel selection: tip = channel, ring = mute, sleeve = ground.
NOTE: With a footswitch attached, the channel
select footswitch overrides the front panel channel switch; the mute footswitch and the front panel mute switch are both active.
24,25. PREAMP OUTPUTS: Connect these
jacks to your power amp(s). If only the Clean/Mix output (25) is used, all outputs
(clean, overdrive, and combined) appear at this jack. When a plug is inserted into the
Overdrive output (24), the clean and overdrive
outputs appear at their respective jacks.
26-29. EFFECTS LOOPS: Each channel of the
preamp has its own effects loop for connecting
external effects. Connect the Send jack (27 or 29, depending on the channel) to the input of
the device, then connect the output of the device to the Return jack (26 or 28).
30,33. BALANCED OUTPUT LEVELS: These
controls adjust the levels of the signals at the Balanced Output jacks: 30 is for Overdrive, 33
is for Clean.
31,34. TRANSFORMER BALANCED OUT - PUT JACKS: These XLR-type jacks can be
used to feed an external power amplifier, mix -
ing console, or house P A system: 31 is for Overdrive, 34 is for Clean. The overdrive out
-
put is post volume and pre master . The clean
channels output is selected via the pre/post
switch (32).
32. PRE/POST: In the post position (switch
out), the signal is post volume, pre master. In the pre position (switch in), the signal is taken
directly from the preamp tube. Its like having a built-in tube direct box in the preamp.
35. TUNER OUT: This jack lets you send a
direct signal from your bass to your tuner ,
regardless of the settings of the preamp. Even with the Mute (3) engaged, the output at this
jack is the same as if you connected directly from your bass.
SVP BSP rear panel:
Technical Specifications:
TOTAL SYSTEM GAIN CLEAN: 22dB, @ 1kHz with levels up, tones flat
OVERDRIVE: 22dB, @ 1kHz with levels up, tones flat
TONE CONTROL RANGE
CLEAN:BASS:20dB range @ 40Hz
MIDRANGE: 21dB range @ 300Hz
TREBLE: 18dB range @ 10kHz
ULTRA LOW: +5dB @ 30Hz
ULTRA HIGH: +8dB @ 8kHz
BRIGHT: +7dB @ 15kHz
OVERDRIVE: BASS:±12dB @ 100Hz
MIDRANGE: +20dB, -5dB @ 300Hz
TREBLE: ±12dB @ 7kHz
SIGNAL TO NOISE RATIO 80dB typical, Clean channel
TUBE COMPLEMENT12AX7 (1)
POWER REQUIREMENTS 120VAC, 60Hz, 15VA; 100/120VAC, 50/60Hz, 15VA; 230VAC, 50/60Hz, 15V A
SIZE AND WEIGHT19 W x 1.75 H x 10 D, 10 lbs.