Aiwa XK S7000 Service Manual

Page 39

IC, L065204A - 4540

Pin No. Pin Name I/O Description
1 WET/[.6 I Remote commander input
2 K - D A T A l I
3 K- DATA 2 I Analog data input of tactile key SW and push key SW
4 K - D A T A 3 I
5 S - D A T A l I
6 S 7 DATAZ I Analog data input of mechanical and AMTS detection SW
7 S - D A T A 3 I
8 A- DATA I Analog data input of MONITOR, CAL selector
9 AV 4" _ }AD converter voltage input terminal.
1 0 AV- __ Applies 5 V to AW and 0 V to AV-.
1 1 V S S - System power supply terminal. Connect to GND.
1 2 O S C 1 I System clock terminal.
1 3 O S C 2 0 Connect to a AMHz crystal clock.
1 4 VDD - System power supply terminal. +5 V connected.
1 5 m I System reset terminal
1 6 X I -˜I VDD connected.
1 7 X 2 0 Not connected.
1 8 TE ST I [.51 test terminal, Connect to GND.
1 9 m 0
2 O D-ļ¬ 0 FL light-up segment output. Lights up when [Lo].
2 1 W O
2 2 ļ¬rs? I/O SD output/AC OFF detection to FL
2 3 W I Memory function Lo pulse input
2 4 I -R E E L I Auto stop reel pulse input
2 5 T-T-"P'L- I
}Mechanical cam position detection reef SW input
2 6 I - S - PA I
2 7 M- S L OW 0 Reel motor control output
2 8 M7 C A P S T O Capstan motor control output
2 9 M- R V S O } ,
Reel motor control output
3 O M- FWD 0
3 1 M- C L O S E O }
AMTS motor control output
3 2 M- O P E N O
3 3 S - P AU S E O PAUSE plunger control output
3 4 S - P L AY O PLAY plunger control output

Page 44

Pin No. Pin Name /0 Description
3 9 S EG 7 O "
4 O S E G 6 O
4 l S E G 5 O
4 2 S E G 4 O
4 3 S E G 3 0 FL light up segment output. Lights up when [H].
4 4 S E G 2 O
4 5 S E G 1 O
4 6 S E G O O _
4 7 GR I D 0 O _
4 8 GRID l 0
FL light up grid output. Lights up when [H].
4 9 GR I D 2 O
5 0 GR I D 3 O -˜
5 1 O - CAL 0 FL light up segment output. Lights up when [H].
5 2 VP v Pull down resistor load supply. Connect to -30V,

Note 1) PU refers to integrated pull
2) PC 0~3 and PD U~3 (Pin No.

up resistor and PD refers to integrated pull down resistor.
23~30) are [L] during the initial stage.

59