Aiwa CA DW537 Owners Manual

This is the 10 pages manual for Aiwa CA DW537 Owners Manual.
Read or download the pdf for free. If you want to contribute, please mail your pdfs to info@audioservicemanuals.com.

Page: 1 / 10
left right
Aiwa CA DW537 Owners Manual

Extracted text from Aiwa CA DW537 Owners Manual (Ocr-read)


Page 2

WARNING

TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE T0 RAIN OR MOISTURE.

RISK OF ELECTRIC SHOCK ,
DO NOT OPEN

“CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK),
N0 USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING T0 QUALIFIED
SERVICE PERSONNEL."

Explanation of Graphical Symbols:

The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alertthe user
to the presence of unlnsulated “dangerous volt-
age" withln the product’s enclosurethat may be of
sufficient magnitude to constitute a risk of electric

shock to persons.

The exclamation point within an equilateral trian-
gle is intended to alen the userto the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the

. 3, appliance.

OWNER’S RECORD

For your convenience, record the model number and serial number
(you will find them at the rear of the unit) in the space provided below.
Please reler to them when you contact your AIWA dealer in case of

difficulty.

Precautions

Read the Operating Instructions carefully and completely
before operating the unit. Be sure to keep the Operating

Instructions for future reference. All warnings and cautions in

the Operating Instructions and on the unit should be strictly
followed, as well as the safety suggestions below.

Installation

1 Water and moisture — Do not use this unit near water,
such as near a bathtub, washbowl, kitchen sink, laundry
tub, in a wet basement, swimming pool, or the like.

2 Heat - Do not use this unit near sources of heat, including

heating vents, stoves, or other appliances that generate
heat.

It also should not be placed in temperatures less than 5°C

(41°F) or greater than 35°C (95°F).

3 Mounting surface - Place the unit on a flat, even surface.

4 Ventilation - The unit should be situated with adequate

space around it so that proper heat ventilation is assured.
Allow 10 cm (4 in.) clearance from the rear and the top of

the unit and 5 cm (2 in.) from each side.

- Do not place the unit on a bed, rug, or similar surface
that may block the ventilation openings.

- Do not install the unit in a bookcase, cabinet. or airtight
rack where ventilation may be impeded.

2 ENGLISH.

' 5 Oblects and liquid entry - Take care that objects or

liquids do not get inside the unit through the ventilation
openings.

6 Carts and stands - When placed or
mounted on a stand or cart, the unit should
be moved with care.
Quick stops, excessive force, and uneven
surfaces may cause the unit or canto
overturn or fall.

7 Condensatlon - Moisture may form on the CD pickup
lens when:
- The unit is moved from a cold spot to a warm spot
- The heating system has just been turned on
- The unit is used in a very humid room
— The unit is cooled by an air conditioner
When this unit has condensation inside, it may not
function normally. Should this occur, leave the unit for a
few hours, then try to operate again.

8 Wall or ceiling mounting - The unit should not be
mounted on a wall or ceiling, unless specified in the
Operating Instructions.

Electric Power

1 Power sources - Use on batteries or AC house current,
as specified in the Operating Instructions and marked on
the unit.

2 Polarization - As a safety feature, some units are
equipped with polarized AC power plugs which can only
be inserted one way into a power outlet. If it is difficult or
impossible to insert the AC power plug into an outlet, turn
the plug over and try again. If it still does not easily insert
into the outlet, please call a qualified service technician to
service or replace the outlet. To avoid defeating the
safety feature of the polarized plug, do not force it into a
power outlet.

3 AC power cord
- When disconnecting the AC power cord, pull it out by

the AC power plug. Do not pull the cord itself.

- Never handle the AC power plug with wet hands, as this
could result in fire or shock.

» Power cords should be firmly secured to avoid being
bent, pinched, or walked upon. Pay particular attention
to the cord from the unit to the power socket.

- Avoid overloading AC outlets and extension cords
beyond their capacity, as this could result in fire or
shock.

4 Extension cord - To help prevent electric shock. do not
use a polarized AC power plug with an extension cord,
receptacle, or other outlet unless the polarized plug can
be completely insened to prevent exposure of the blades
of the plug.

5 When not In use - Unplug the AC power cord from the
AC outlet or remove all the batteries if the unit will not be
used for several months or more. When the cord is
plugged in, a small amount of current continues to flow to
the unit, even when the power is turned off.

Maintenance

Clean the unit only as recommended in the Operating
Instructions.

Damage Requiring Service

Have the units serviced by a qualified service technician if:

- The AC power cord or plug has been damaged

- Foreign objects or liquid have got inside the unit

- The unit has been exposed to rain or water

- The unit does not seem to operate normally

- The unit exhibits a marked change in performance

- The unit has been dropped, or the cabinet has been
damaged

MW