Aiwa AW PZP1 Owners Manual

Page 1

2GB To prevent fire or shock hazard, do not expose the unit to rain or moisture. To prevent fire, do not cover the ventilation of the apparatus with news papers, table-cloths, curtains, etc. And dont place lighted candles on the apparatus. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus. This appliance is classified as a CLASS 1 LASER product. This marking is located on the rear exterior. Dont throw away the battery with general house waste, dispose of it correctly as chemical waste. NOTICE FOR THE CUSTOMERS IN THE U.S.A. This symbol is intended to alert the user to the presence of uninsulated dangerous voltage within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. CAUTION The use of optical instruments with this product will increase eye hazard. WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -“ Reorient or relocate the receiving antenna. -“ Increase the separation between the equipment and receiver. -“ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -“ Consult the dealer or an experienced radio/TV technician for help. Note to CATV system installer: This reminder is provided to call the CATV system installers attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. CAUTION You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. WARNING Do not install the appliance in a confined space, such as a bookcase or built-in cabinet.

Page 2

3GB NOTICE FOR THE CUSTOMERS IN THE U.S.A. If you have any questions about this product, you may call; Aiwa Customer Information Service Center 1-800-289-2492 or http://www.us.aiwa.com/ The Number below is for the FCC related matters only. Regulatory Information NOTICE FOR THE CUSTOMERS IN CANADA CAUTION The use of optical instruments with this product will increase eye hazard. CAUTION TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. Except for European model ENERGY STAR ® is a U.S. registered mark. As an E NERGY S TAR ® partner, Sony Corporation has determined that this product meets the E NERGY STAR ® guidelines for energy efficiency.  Microsoft, Windows and Windows NT are trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries.  IBM and PC/AT are registered trademarks of International Business Machines Corporation.  Macintosh is a trademark of Apple Computer, Inc. in the United States and/or other countries.  Pentium is a trademark or registered trademark of Intel Corporation.  All other trademarks and registered trademarks are trademarks or registered trademarks of their respective holders.  -„¢ and ® marks are omitted in this manual. Declaration of Conformity Trade name: AIWA Model No.: CX-LZP5 Responsible Party: Sony Electronics Inc. Address: 16450 W. Bernardo Dr, San Diego, CA 92127 U.S.A. Telephone No.: 858-942-2230 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Page 31

32GB Tuner Severe hum or noise/stations cannot be received.  Set the proper band and frequency (page 13).  Connect the antenna properly (page 8).  Find a place and an orientation that provide good reception, then set up the antenna again. If you cannot obtain good reception, we recommend you connect a commercially available external antenna.  The supplied FM lead antenna receives signals along its entire length, so make sure you extend it fully.  Keep the antennas away from the system and other components.  Consult your nearest Aiwa dealer if the supplied AM antenna has come off the plastic stand.  Try turning off surrounding electrical equipment.  Set CD POWER OFF by CD power manage function (page 14). A stereo FM program cannot be received in stereo.  Press FM MODE until MONO disappears in the display. Noise is heard while loading/removing a disc.  Change the location of the AM antenna. Personal computer (except for AWP-ZP1) There is no sound.  Connect the personal computer properly.  Press PC (or FUNCTION repeatedly) to select PC (page 26).  Select the standard audio device in the Multimedia or Sounds and Multimedia (for Windows 2000/Me/98 Second Edition) or Sounds, Speech, and Audio Devices (for Windows XP) on the Control Panel of the computer. Optional components There is no sound.  Refer to General item There is no sound. (page 30) and check the condition of the system.  Connect the component properly (page 28) while checking: -“ if the cords are connected properly. -“ if the cord plugs are firmly inserted all the way.  Turn on the connected component.  Refer to the operating instructions supplied with the connected component and start playing.  Press FUNCTION repeatedly (or MD* on the unit) to select MD (page 29). *AWP-ZP1 only The sound is distorted.  Set the volume of the connected component lower. If the system still does not operate properly after performing the above measures, reset the system as follows: 1Disconnect the power cord. 2Reconnect the power cord. 3Press ?/1 to turn on the system. 4Hold down ?/1 and then press i-Bass on the unit for 2 seconds. The system is reset to the factory settings. You should set the settings you made, such as the preset stations, clock, and timer.

Page 35

36GB Outputs PHONES (stereo mini jack): Accepts headphones with an impedance of 8 ohms or more SPEAKERS: Accepts impedance of 6 ohms USB hub ports (AWP-ZP5 only) Maximum current consumption: 100 mA per port CD player section System Compact disc and digital audio system Laser Semiconductor laser (λ=780 nm) Emission duration: continuous Frequency response 2 Hz -“ 20 kHz Tuner section FM stereo, FM/AM superheterodyne tuner FM tuner section Tuning range North American model: 87.5 -“ 108.0 MHz (100-kHz step) Other models: 87.5 -“ 108.0 MHz (50-kHz step) Antenna FM lead antenna Antenna terminals 75 ohms unbalanced Intermediate frequency 10.7 MHz AM tuner section Tuning range Pan-American model: 530 -“ 1,710 kHz (with the tuning interval set at 10 kHz) 531 -“ 1,710 kHz (with the tuning interval set at 9 kHz) European model: 531 -“ 1,602 kHz (with the tuning interval set at 9 kHz) Other models: 530 -“ 1,710 kHz (with the tuning interval set at 10 kHz) 531 -“ 1,602 kHz (with the tuning interval set at 9 kHz) Antenna AM loop antenna, external antenna terminal Intermediate frequency 450 kHz Speaker (SSX-LZP5) Speaker system 2-way, bass-reflex type, magnetically shielded type Speaker units Woofer: 10 cm dia., cone type Tweeter: 4 cm dia., cone type Nominal impedance 6 ohms General Power requirements North American model: 120 V AC, 60 Hz European model: 230 V AC, 50/60 Hz Australian model: 230 -“ 240 V AC, 50/60 Hz Korean model: 220 V AC, 60 Hz Taiwan model: 120 V AC, 50/60 Hz Other models: 110 -“ 120, 220 -“ 240 V AC, 50/60 Hz Adjustable with voltage selector Power consumption European model: 40 W 0.3 W (in Power Saving mode) North American and Korean models: 40 W Other models: 45 W Dimensions (w/h/d) incl. projecting parts and controls Amplifier/Tuner/CD section: Approx. 108 × 224.8 × 327.1 mm Speakers: Approx. 115 × 225 × 223 mm Mass Amplifier/Tuner/CD section AWP-ZP5: Approx. 4.4 kg AWP-ZP3/ZP1: Approx. 4.2 kg Speakers: Approx. 3.8 kg net per speaker Supplied accessories Remote commander (1) R6 (size AA) batteries (2) AM loop antenna (1) FM lead antenna (1) Speaker cables (2) USB cable (except for AWP-ZP1) (1) USB Hub Port Information (AWP-ZP5 only) (1) Design and specifications are subject to change without notice.