Kenwood KX 1100 G Service Manual

Page 2

DISASSEMBLY FDR REPAIR . D'ISASSEMBLY FDR REPAIR

1 Press EJECT knob ( 0N1 pull out the cassette holder,
remove me eassene lid (9 ), and then reset the asset-
se holder.

2. Remove 3 screws on the upper part of the panel and
3 screws on (he lower part ( a ),and remove [[15 panel

10). l

Note : when assembling the sub-panel assembly and chassis.
inset: thu chasiss claw m the inside as shown in
® . and pm: the sub-panel into a pmjection of she
chassis (A) as shown in

Submnul

8. Remove 3 screws which fasten the display mm (6 i.
remove 3 hooks fixed on the sub-panel l® l, and Roi-mm
then pull am the dispiay unit toward you (@L (XZSHB/G)

@/

3. Remove (he color filters of the level meter and the
counterxe),

4. Remove 4 CALIBRATION (BIAS. LEVEL) knobs
(9)and FRESETlL) kncbie).

5s Insen (4) screw drlver in she escutcheon hole (6 l,
and pull out STOP knob toward you i 9 l.

9. Remove 2 screws which fasten the display unit and
escutcheon ( ® ).
10. Remove 5 hooks ( 9 ), and disassemble the display
unit and escuthchecn ( @ )s
11. Remove 4 screws on both ends of from side of (he subv
panel ( Q l, and remove ihe mechanism assembly to
the rear side.

on

. Bend the chassis claw outmrd ( ® i.
7. Remove 3 screws (0 1 on me rear of me panel and 6
screws ( ® ) on the chassis, and than puli out the sub
panel assembly slightly toward you and set it upright
(Q . Q ). ~

DISPLAY UNIT 1
@